Abstract:Gafchromic EBT (EBT) films are becoming increasingly popular due to their advantageous properties. When flatbed colour scanners are used for film dosimetry, a good quality control of the scanning device is a crucial step for accurate results. The proposal of this work was to fully assess the performance of the scanner Epson Expression 10000XL in order to quantify all parameters and needed corrections to minimize dose uncertainties. A standard step tablet, with 32 steps and optical densities from 0.06 to 3.8, was used to check the scanner linearity. The scanner warming-up effect and reproducibility were evaluated by performing 30 consecutive scans plus 20 scans in 15 min intervals. The scanning colour modes: 24 and 48 bits and scanning resolutions from 50 to 300 dpi were tested. A Wiener filter with different pixels regions was applied with the purpose of reducing the film noise. All scans were made in transmission mode with a constant film orientation. The red colour channel was posteriorly extracted from the images to maximize readout sensitivity. Two EBT films were irradiated, perpendicularly and parallel to beam incidence, with a 6 MV photon beam with doses that ranged from 0.2 to 3 Gy. A polynomial expression was used to convert optical density into dose. Dose uncertainty was quantified applying error propagation analysis. A correction for the non-uniform response of the scanner was determined using five films irradiated with a uniform dose. The scanner response was linear until an optical density of approximately 1 which corresponds to doses higher than those of clinical interest for EBT films. The scanner signal stabilized after seven readings. Scanner reproducibility around 0.2% was obtained either with the scanner warm or cold. However, reproducibility was significantly reduced when comparing images digitized with the scanner at different temperatures. Neither the colour depth mode, the scanning resolution, the multiscan option nor the Wiener filter had a significant effect on the shape of the calibration curve. However, a reduction in dose uncertainty was possible by selecting appropriate reading parameters. These are a 48 bit colour depth, a 75 dpi resolution and repeating the scan four times. Finally, the two dimensional Wiener filter applied to a 3 x 3 pixel region to the red component of the image reduced the experimental scan uncertainty to about 0.5% for doses higher than 0.5 Gy. Total scan uncertainty was less than 2% for a perpendicular calibration and reduced to less than 1% for a parallel calibration. A dose over-estimation of around 5% for clinical doses may be made if the image acquired is not corrected for the non-uniform response of the scanner. A protocol to read EBT films using the Epson Expression 10000XL scanner was established for IMRT verification. The contribution for the overall uncertainty in film dosimetry coming from the scanning process was estimated to be around 0.5% for doses higher than 0.5 Gy when reading parameters are optimized. Total scan uncertainty achieved is about 2% when using a perpendicular calibration. It can further be reduced if a parallel calibration is used.

Magnetic fields are causing small, but significant changes of the radiochromic EBT3 film response to 6 MV photons

Organic Magnetic-Field Effect Examined in Frequency Domain and Time Domain

Clinical Utility of Gafchromic Film in an MRI-guided Linear Accelerator

Dose-response curve of EBT, EBT2, and EBT3 radiochromic films to synchrotron-produced monochromatic x-ray beams

On the color channel's effect on the dose-response of Gafchromic EBT2 and EBT3 radiochromic films to 6 MeV electron beam

Characterization of scanning orientation and lateral response artifact for EBT4 Gafchromic film

Evaluation of a new radiochromic film dosimeter, Gafchomic EBT4, for VMAT, SABR and HDR treatment delivery verification

Comprehensive evaluation and new recommendations in the use of Gafchromic EBT3 film

Evaluation of an Epson flatbed scanner to read Gafchromic EBT films for radiation dosimetry

Reading of gafchromic EBT-3 film using an overhead scanner

Carbon ion beam dosimetry in magnetic fields using Farmer-type ionization chambers of different radii: measurements and simulations

The Biological Effects of Magnetic Fields on Microvascular Endothelial Cells in the Human Brain

Monte Carlo calculated absorbed‐dose energy dependence of EBT3 and EBT4 films for 5–200 MeV electrons and 100 keV–15 MeV photons

Post-irradiation darkening model for EBT-3 films characterized using a single lot calibration approach

Clinical use of Gafchromic EBT4 film for in vivo dosimetry for total body irradiation

Characterization of GafchromicTM EBT4 film with clinical kV/MV photons and MeV electrons

CalciumEffluxof PlasmaMembraneVesicles Exposed toELFMagnetic Fields Testofa

Absorption spectrum of Gafchromic EBT2 film with angular rotation

Effect of Magnetic Field on the Structure and Sorption Properties of Films Based on Hydroxyethyl Cellulose and Carbon Nanotubes

Dosimetry in MRgPT: Impact of magnetic fields on TLD dose response during proton irradiation

Feasibility of normal tissue dose reduction in radiotherapy using low strength magnetic field