Zur Vervollkommnung der quantitativen Phytoplankton-Methodik

Hans Utermöhl

DOI: https://doi.org/10.1080/05384680.1958.11904091

1958-01-01

Abstract:Certain species will not fall to the bottom of the counting-chamber unless treated in some way. A solution of iodine in potassium iodide approaches most nearly the ideal fixative, whose six features are listed. The addition of some other substance is necessary to make certain species sink. In containers of good glass with glass stoppers or waxed corks, the iodine in potassium iodide solution with sodium acetate is a satisfactory preservative.The principle of the method is that algae are allowed or caused to fall to the bottom of a tube and are then counted from beneath with the aid of an inverted microscope (figs. 1 and 2). An essential adjunct is a first-class movable stage, and an eyepiece crossed by three lines, one fixed, the other two at right-angles to it and capable of being brought closer together or moved apart (fig. 12). A camera that can be fitted easily is useful (fig. 2). The counting-chambers consist of perspex tubes with very thin glass bottoms; they can be made by sticking cover slips to simple tubes. Table 1 shows suitable dimensions for different volumes of water, the latter varying according to the density of plankton, which subject is discussed more fully in section D VIII. If the whole catch is to be counted a simple tube can be used, but if only part is to be counted even distribution of algae over the bottom must be ensured by use of a filling-tube (fig. 5G) which sits on top of the main tube (fig. 4), and is separated from it by a plate pierced with seven holes (fig. 1). If it is desired to use a condenser (fig. 10), the sample must be contained in a flat chamber (fig. 5 C). A cylinder with a square collar at the base (fig. 5 B) is superimposed upon it and a filling-chamber fitted to the top (fig. 6). After use, the filling-chamber is replaced by a cover (fig. 7, fig. 5 A) and, after 24 hours or so have been allowed for sedimentation, the cylinder is gently pushed off the flat chamber onto a square of exactly the same height (figs. 8 and 9 and fig. 5 D and E).The conflicting demands of saving time and being accurate are discussed. Statistical theory is omitted but it is recommended as a rule of thumb that there should not be less than 100 specimens of the important species in any count. A duplicate of each sample should be examined. Methods of counting a fraction of a sample are described (figs. 13, 14 and 15).