Abstract:Identification of microstructure defects, which are stress concentrators (SC) during the operation of mechanical engineering products, is an important scientific and practical task relevant for manufacturing enterprises. This problem becomes especially urgent and difficult for critical helicopter parts made of sheet TRIP steel VNS9-Sh (23Kh15N5AM3-Sh) and operating under cyclic loads due to the complex microstructure of the steel and small thickness of strips and sheets. To assess the impact of structural defects on the cyclic strength of products made of the steel under study, the specimens were preliminary sorted proceeding from the results of their testing using the method of metal magnetic memory (MMM) and metallographic studies. The MMM method is a structure-sensitive procedure which provides information about the presence of structural defects that arise during the manufacture. Magnetic anomalies in the form of sharp local changes in the intrinsic stray magnetic field (SSMF) ( H ) and its gradient |Δ H | along the length of the controlled section Δ x , were identified on the surface of sheets cut from five different batches. A conventional classification of the identified anomalies was made according to the magnitude of the magnetic field gradient. The specimens of two types were cut in zones of magnetic anomalies and outside them: type 1 — for cyclic tests and type 2 — for metallographic studies. The geometric parameters and field gradient values of magnetic anomalies on specimens of type 1 and type 2 were the same. Metallographic studies in zones of maximum magnetic field gradient on type 2 specimens revealed defects in the form of a strip at the boundary of different structures, which is a structural stress concentrator (SSC) and a source of the inhomogeneity and changes in the magnetic properties. Type 1 specimens with similar magnetic anomalies and Type 1 specimens cut from sheets outside zones of magnetic anomalies were then selected for cyclic testing. Comparative tests for cyclic strength of the specimens with and without specified SSC were carried out. It is shown that the presence of SSC zones in the specimens reduces the number of cycles to failure during cyclic tests by 1 – 2 orders of magnitude compared to the specimens free of SSC. Based on cyclic tensile tests of specimens, a limiting value of the magnetic field gradient was determined that corresponds to the acceptable level of stress concentration on structural defects. This value is recommended for use as a rejection criterion when examining a new tape by the MMM method.

Detection of local stress concentration zones in engineering products—the lacking link in the non-destructive testing system

Application of the metal magnetic memory method for detection of defects at the initial stage of their development for prevention of failures of power engineering welded steel structures and steam turbine parts

Investigation of Stress Concentration and Microdefect Identification in Ferromagnetic Materials within a Geomagnetic Field

Development of a metal magnetic memory method

Progress in Nondestructive Evaluation of Stress Concentration with MMM Method

The metal magnetic memory method application for online monitoring of damage development in steel pipes and welded joints specimens

Magnetic Memory Detect and Maintain Ferromagnetic Component Early

Identification of Magnetomechanical Phenomena in a Degradation Process of Loaded Steel Elements

Stress State Detection Based on Metal Magnetic Memory Theory

Multi-channel non-destructive testing of steel strip stress based on magneto-elastic effect

Characterization of the Elastic-Plastic Region Based on Magnetic Memory Effect

Magnetomechanical Measurements for Nondestructive Evaluation of Failure in Steel Structural Element

Stress Measurement of Ferromagnetic Materials Using Hybrid Magnetic Sensing.

Characterization of Magnetic Field in Crack Propagation Stage and Application to Non-Destructive Evaluation

Study of metal magnetic memory (MMM) technique using permanently installed magnetic sensor arrays

A stress defect state measurement method based on low-frequency ACMFL excitation and hall sensor array collection

Quantitative Nondestructive Evaluation of Mechanical Damages Based on the Phenomena of Natural Magnetization

Magnetic Signals of Stress Concentration Detected in Different Magnetic Environment

Analysis of Damage ' s Influences on Metal

Identification of structural defects and their impact on the magnetic memory, static and cyclic strength of VNS9-SH thin sheet trip-steel

Early damage stress state MMM testing