Abstract:Structural Health Monitoring, Ahead of Print. Bridge damage detection using vibration data has been confirmed as a promising approach. Compared to the traditional method that typically needs to install sensors or systems directly on bridges, the drive-by bridge damage detection method has gained increasing attention worldwide since it just needs one or a few sensors instrumented on the passing vehicle. Bridge frequencies extracted from the vehicle's vibrations can be good references for damage detection. However, extant literature considered mainly low-frequency responses of the vehicle, while the high-frequency responses that also contained the bridge's damage information were often ignored. To fill this gap, this paper developed a damage detection approach that utilized both low and high-frequency responses of the passing vehicle. Mel-frequency cepstral coefficients (MFCCs) and support vector machine (SVM) were employed to classify damage severity. Firstly, the vehicle's frequency responses are utilized as input features to train SVM models to identify the bridge's condition. Then, to reduce dimensions of inputs and improve training efficiency, frequency responses are projected from the Hertz scale into the Mel scale, and two means using MFCCs are used to feed different SVM models. A laboratory experiment with a U-shaped continuous beam and a model car was used to verify the effectiveness of the proposed method. Results showed that high-frequency responses contain much information about the bridge's conditions, and using MFCCs could apparently improve computational efficiency. The errors of damage detection when a heavy car was employed were within 5%.

Output-Only Damage Detection of Steel Beam Using Moving Average Filter

Beam Damage Detection Under a Moving Load Using Random Decrement Technique and Savitzky–Golay Filter

Application of the Random Decrement Technique in Damage Detection under Moving Load

Damage detection based on accelerometers and computer vision measurements of moving load-induced structural responses

Damage Assessment Using The Energy Dissipation Ratio Of Acceleration Signals

Structural damage detection based on Kalman filter and neutral axis location

LOCAL DAMAGE DETECTION OF SIMPLY SUPPORTED BEAM ON THE EXCITATION OF MOVING LOAD BASED ON AVERAGE CURVATURE MODAL

Damage detection method based on operating deflection shape curvature extracted from dynamic response of a passing vehicle

Structural Damage Detection Based on Structural Macro-Strain Mode Shapes Extracted From Non-Stationary Output Responses

Experimental Study of Structural Damage Identification Based on Modal Parameters and Decay Ratio of Acceleration Signals

Damage detection in a fixed-fixed beam using natural frequency changes

Efficient Bayesian FFT Method for Damage Detection Using Ambient Vibration Data with Consideration of Uncertainty

An Investigation into the Application of Acceleration Responses' Trendline for Bridge Damage Detection Using Quadratic Regression

Fourier Spectral-Based Modal Curvature Analysis and Its Application to Damage Detection in Beams

Damage Detection Based on Bayes Factor Using Ambient Vibration Data

Stayed-Cable Bridge Damage Detection and Localization Based on Accelerometer Health Monitoring Measurements

Auto-Regressive Integrated Moving-Average Machine Learning for Damage Identification of Steel Frames

A signal energy change-based damage localization approach for beam structures

Drive-by bridge damage detection using Mel-frequency cepstral coefficients and support vector machine

Fractal Theory and Wavelet Packet Transform Based Damage Detection Method for Beam Structures

Improved Damage Detection for Beam-type Structures Using a Uniform Load Surface