Abstract:The objective of this work is to present an integral methodology to numerically model the wear phenomena by friction in a polymer–metal contact pair, showing the development of a numerical tool to implement a wear model in the commercial finite element code Abaqus. The contact pair in which this work is based corresponds to the contact between a guide shoe insert for an elevator, made of thermoplastic polyurethane elastomers (TPU), and the corresponding guide, made of steel. Tribometer tests are planned to fit the numerically implemented wear model as well as to validate it. These tests are briefly described as an introduction to the numerical fitting of the data from which the wear model is obtained. The numerical tool in which the wear model in a polymer–steel contact pair is implemented is based on a methodology that combines the use of the user subroutine Umeshmotion, which offers the possibility of implementing a wear model in any general form, several routines to result access, and the adaptive meshing technique, a mesh smoothing tool available in Abaqus based on ALE (Augmented Lagrangian Eulerian) methods. With this technique, it is possible to eliminate material during the simulation as well as to maintain a high-quality mesh throughout an analysis by allowing the mesh to move independently of the material. As the tests that are carried out in the tribometer to fit and to validate the wear model require long travel distances and a large number of cycles, a real simulation of those tests would require a huge calculation time. Therefore, to simulate the wear process equivalent to the travelled distances in the tests in an affordable simulation time, an accelerated numerical procedure of the wear process is also proposed in this work. To numerically implement the wear model, and as it is usually stated in polymers, it is previously necessary to set up a procedure for determining the relationship between the friction coefficient and the contact pressure for the material and countermaterial contact pair. Finally, a validation of the methodology with a new wear tribometer test under different conditions to those stated to characterise the model is also presented.

Methodology development to design a representative test specimen for wear damage in spline couplings

Test Rig for Spline Couplings Working in Misaligned Conditions

Experimental characterization of roughness parameters for fretting wear in spline couplings

Modification methodology of fretting wear in involute spline

Wear Characteristics of the Material Specimen and Method of Predicting Wear in Floating Spline Couplings of Aero-Engine

Oil debris monitoring in misaligned spline couplings subjected to fretting wear

Uncertainty evaluation of Ruiz parameter for spline coupling wear analysis

Prediction of fretting wear in aero-engine spline couplings made of 42CrMo4

Experimental Study of Spline Wear and Lubrication Effects

Wear Mechanisms of the Working Surface of Gears after Scuffing Tests

Experimental investigation and prediction method of fretting wear in rack-plane spline couplings

Analysis of factors affecting the wear failure of an aeroengine spline pair and evolution mechanism of the tribolayer

Mechanism and Prediction Method of Fretting Damage in Involute Spline Couplings of Aero-engine

Finite element implementation and validation of wear modelling in sliding polymer–metal contacts

Experimental lap-shear tests on friction dampers with single and double slotted holes

Studying the Performance of Reinforced Polymer Gear Wheels: Development of an Advanced Test Bench for Wear Analysis

On the usage of pulsator data within the load spectra assessment of gears

A Study on the Influence of Nonlinear Vibration on Fretting Damage of Involute Spline Pairs in Aero-Engines

A New Design of the Universal Test Rig to Measure the Wear Characterizations of Polymer Acetal Gears (Spur, Helical, Bevel, and Worm)

Friction coefficient and wear mode transition in micro-scale abrasion tests

Optimization of the Scratch Test for specific coating designs