Abstract:<p>A two-span and three-story of the frame specimen with a scale of 1:2.5 was tested and investigated under cyclic loading to study the seismic behavior on the composite frame consisting of steel reinforced recycled concrete columns and steel beams. After observing the loading process and failure modes, the mechanical properties of composite frame, such as the load–displacement hysteretic curves, skeleton curves, bearing capacity, interstory displacement angles, ductility, energy dissipation and stiffness degradation, were analysed in detail. On this basis, a finite element model of the composite frame which considered the constitutive properties of recycled concrete was established. The deformation diagram, stress nephogram and calculated skeleton curves of composite frame were obtained, and a nonlinear parameter analysis was also conducted. The experimental and numerical analysis results all show that the plastic hinges appeared at the end of steel beams firstly and then formed at the end of columns, which is a typical plastic hinge failure of frame. The hysteretic curves of frame are shuttle-shaped and full, and the descending section of the skeleton curves and stiffness degradation curves is relatively gentle. The average ductility coefficient, equivalent viscous damping coefficient and ultimate interstory displacement angle of frame are 3.205, 0.303 and 0.04, respectively. Therefore, the composite frame has good deformation, energy dissipation capacity and collapse resistance. The results of the nonlinear parameter analysis on the frame also exhibit that increasing the strength of steel products or recycled concrete is beneficial to the horizontal bearing capacity and lateral stiffness of frame. The maximum increase in the bearing capacity of frame can be 21.5% when the profile steel strength is increased from Q235 to Q390 and the recycled concrete strength is maintained at C40 within the parameters analysed, but the increase in material strength is unfavourable to the deformation capacity of frame. Increasing the axial compression ratio of columns in the frame obviously weakens the lateral displacement ductility of frame, which makes the frame unsafe under an earthquake. In addition, the bearing capacity and stiffness of frame increases with the increase in the linear stiffness of beams and columns. The research conclusions can provide a reference for the engineering application of this type of composite frame.</p>

Experimental and numerical study on seismic performance of steel reinforced recycled concrete frame structure under low-cyclic reversed loading

Seismic Performance of Circular Recycled Aggregate Concrete-Filled Steel Tubular Columns: FEM Modelling and Sensitivity Analysis

A review of experimental results on structural performance of reinforced recycled aggregate concrete beams and columns

Quasi-static Testing and Networked Pseudo-Dynamic Testing on Fiber Reinforced Plastic Retrofitted Reinforcement Concrete Short Columns of Bridge

Experimental Study on Progressive Collapse-Resistant Behavior of Reinforced Concrete Frame Structures

Seismic behavior of steel-reinforced recycled concrete inner-beam–column connection under low cyclic loads

Cyclic loading test and nonlinear analysis on composite frame consisting of steel reinforced recycled concrete columns and steel beams

Experimental research on seismic behavior of concrete column with spatial steel frame subjected to low cyclic reversed load

Study on Seismic Performance of Recycled Steel Fibers Locally Reinforced Cruciform Concrete Frame Beam-Column Joint

Seismic Behavior of Concrete-Filled Circular Steel Tubular Column–Reinforced Concrete Beam Frames with Recycled Aggregate Concrete

Mechanical behavior of lattice steel reinforced concrete inner frame with irregular section columns under cyclic reversed loading

Cyclic behavior of concrete-filled steel tubular column–reinforced concrete beam frames incorporating 100% recycled concrete aggregates

Research on seismic properties of steel reinforced PP ECC column

Experimental study on seismic behavior of recycled aggregate concrete infilled profile steel structures

Experimental study on seismic performance of RC frames reinforced with high-strength steel

Seismic performance of conrete‐filled steel tube column‐reinforced concrete beam frame using 100% recycled coarse aggregate

Nonlinear Analysis and Test Validation on Seismic Performance of A Recycled Aggregate Concrete Space Frame

Seismic Performance of Nonprestressed and Prestressed HPC Frames under Low Reversed Cyclic Loading

Seismic Behavior of Steel Reinforced Ultra-High Strength Concrete Composite Frame: Experimental and Numerical Study

Seismic reinforcement analysis and measurement research of reinforced concrete frame structure

Numerical and experimental analysis in seismic performance of post-earthquake reinforced concrete frame retrofitted with ECC