Abstract:The optimization of gearbox ratios is crucial for achieving a balance between fuel consumption, power performance, and comfort in vehicles by regulating engine operating conditions. However, challenges exist due to the complexity of powertrain efficiency and uncertainty of future operating conditions. In this paper, a gear model prediction control algorithm based on future operating condition prediction and model accuracy compensation is proposed for a heavy-duty truck equipped with an automated manual transmission (AMT). First, a power demand and expected vehicle speed prediction algorithm is proposed using historical throttle pedal action data and vehicle dynamics model, aiming to compensate for driver intention uncertainty. Second, for the predicted operating conditions, a nonlinear model predictive control (NMPC) is used to optimize the transmission ratio with multiple objectives such as fuel consumption, power performance, and smoothness, and then discretized to the required gear ratio. Finally, the deviation between the NMPC model and the actual powertrain system is actively observed and compensated using an extended state observer (ESO) to improve the robustness to uncertainty factors such as vehicle weight and slope. Simulation results show that: 1) Under the condition of deep throttle acceleration, the future operating condition prediction MPC algorithm can save about 5.67% fuel. 2) With the use of ESO, the vehicle speed tracking error is reduced by 27.6%, and energy consumption is improved by 3.51% when the vehicle cargo weight changes by 50%. 3) In a typical 65-second acceleration segment, the fuel consumption of this algorithm is reduced by 0.64% compared with the traditional offline MAP algorithm, and the vehicle speed tracking error is reduced by 2.52%.

Optimal preview position control for shifting actuators of automated manual transmission

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Analysis and Modeling for Electro-pneumatic AMT System

Position and Force Switching Control for Gear Engagement of Automated Manual Transmission Gear-Shift Process

Improved Decoupling Control for a Powershift Automatic Mechanical Transmission Employing a Model-Based PID Parameter Autotuning Method

Shifting Control of Automatic Mechanical Transmissions for Electric Vehicles Based on Optimal Control Theory

Optimal Tracking Control for Automatic Transmission Shift Process

Precise and coordinated gearshift control for AMT gearshift system equipped with two linear actuators

Gear-shifting control of non-synchronizer electric-driven mechanical transmission with active angle alignment

Shift Modeling Based on Long Short-Term Memory for Manual Transmission System and Shift Process Improvement by Using Bionic Optimization

An improved adaptive position tracking strategy for automatic shift actuator with uncertain parameters

Controller design for electro-hydraulic actuator of heavy-duty automatic transmission using model predictive control algorithm

Integrating Gear Shifting Preference into Personalized Shift-Scheduling Calibration

Research on shifting process control of automatic transmission

Shifting Process Optimization of Dedicated Hybrid Transmission.

Shifting Control Strategy Research in the Hard Accelerating Condition Based on the AMT Vehicle

Model-based gear-shift optimization for an automated manual transmission

Time-Optimal Coordination Control for the Gear-Shifting Process in Electric-Driven Mechanical Transmission (dog Clutch) Without Impacts

Antishudder Gearshift Controller Design for Automatic Transmission

Extended Stated Model Predictive Control Algorithm for Gearbox Gearshifting of Heavy-Duty Trucks with Operation Condition Prediction

System dynamic modelling and adaptive optimal control for automatic clutch engagement of vehicles