Abstract:The optimization of gearbox ratios is crucial for achieving a balance between fuel consumption, power performance, and comfort in vehicles by regulating engine operating conditions. However, challenges exist due to the complexity of powertrain efficiency and uncertainty of future operating conditions. In this paper, a gear model prediction control algorithm based on future operating condition prediction and model accuracy compensation is proposed for a heavy-duty truck equipped with an automated manual transmission (AMT). First, a power demand and expected vehicle speed prediction algorithm is proposed using historical throttle pedal action data and vehicle dynamics model, aiming to compensate for driver intention uncertainty. Second, for the predicted operating conditions, a nonlinear model predictive control (NMPC) is used to optimize the transmission ratio with multiple objectives such as fuel consumption, power performance, and smoothness, and then discretized to the required gear ratio. Finally, the deviation between the NMPC model and the actual powertrain system is actively observed and compensated using an extended state observer (ESO) to improve the robustness to uncertainty factors such as vehicle weight and slope. Simulation results show that: 1) Under the condition of deep throttle acceleration, the future operating condition prediction MPC algorithm can save about 5.67% fuel. 2) With the use of ESO, the vehicle speed tracking error is reduced by 27.6%, and energy consumption is improved by 3.51% when the vehicle cargo weight changes by 50%. 3) In a typical 65-second acceleration segment, the fuel consumption of this algorithm is reduced by 0.64% compared with the traditional offline MAP algorithm, and the vehicle speed tracking error is reduced by 2.52%.

Controller design for electro-hydraulic actuator of heavy-duty automatic transmission using model predictive control algorithm

Simultaneous Control of Motion and Maximized Stiffness for an Electro-Pneumatic Clutch Actuator Based on Pressure Observers

A Two-stage Optimal Controller for Hydraulic Loading System with Mechanical Compensation

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Shift Modeling Based on Long Short-Term Memory for Manual Transmission System and Shift Process Improvement by Using Bionic Optimization

Antishudder Gearshift Controller Design for Automatic Transmission

Gearshift Controller Design For Automatic Transmission

Research on shifting process control of automatic transmission

Model-based gear-shift optimization for an automated manual transmission

Research on Intelligent Self-Learning System for the Electro-Pneumatic Automated Manual Transmission Gear Position

Optimal preview position control for shifting actuators of automated manual transmission

A Fuzzy Logic Control-Based Adaptive Gear-Shifting Considering Load Variation and Slope Gradient for Multi-Speed Automated Manual Transmission (AMT) Electric Heavy-Duty Commercial Vehicles

Extended Stated Model Predictive Control Algorithm for Gearbox Gearshifting of Heavy-Duty Trucks with Operation Condition Prediction

Position and Force Switching Control for Gear Engagement of Automated Manual Transmission Gear-Shift Process

Optimal Tracking Control for Automatic Transmission Shift Process

Shifting Process Optimization of Dedicated Hybrid Transmission.

Improved Decoupling Control for a Powershift Automatic Mechanical Transmission Employing a Model-Based PID Parameter Autotuning Method

System dynamic modelling and adaptive optimal control for automatic clutch engagement of vehicles

Optimizing the Control of the Hydraulic Driving System for the Power Shift Gearbox of a Cotton Picker Based on Dual Working Conditions

Research on the Optimal Control of Working Oil Pressure of DCT Clutch Based on Linear Quadratics Form

Shifting Control Strategy Research in the Hard Accelerating Condition Based on the AMT Vehicle