Abstract:This study focused on exergo–conomic and parametric analysis for Taji station in Baghdad. This station was chosen to reduce the emission of waste gases that pollute the environment, as it is located in a residential area, and to increase the production of electric power, since for a long time, Iraq has been a country that has suffered from a shortage of electricity. The main objective of this work is to integrate the Taji gas turbine's power plant, which is in Baghdad, with the Rankine cycle and organic Rankine cycle to verify waste heat recovery to produce extra electricity and reduce emissions into the environment. Thermodynamic and exergoeconomic assessment of the combined Brayton cycle–Rankine cycle/Organic Rankin cycle (GSO CC) system, considering the three objective functions of the First- and Second-Law efficiencies and the total cost rates of the system, were applied. According to the findings, 258.2 MW of power is produced from the GSO CC system, whereas 167.3 MW of power is created for the Brayton cycle (BC) under the optimum operating conditions. It was demonstrated that the overall energy and exergy efficiencies, respectively, are 44.37% and 42.84% for the GSO CC system, while they are 28.74% and 27.75%, respectively, for the Brayton cycle. The findings indicate that the combustion chamber has the highest exergy degradation rate. The exergo–economic factor for the entire cycle is 37%, demonstrating that the cost of exergy destruction exceeds the cost of capital investment. Moreover, the cost of the energy produced by the GSO CC system is USD 9.03/MWh, whereas it is USD 8.24/MWh for BC. The results also indicate that the network of the GSO CC system decreases as the pressure ratio increases. Nonetheless, the GSO CC system's efficiencies and costs increase with a rise in the pressure ratio until they reach a maximum and then decrease with further pressure ratio increases. The increase in the gas turbine inlet temperature and isentropic efficiency of the air compressor and gas turbine enhances the thermodynamic performance of the system; however, a further increase in these parameters increases the overall cost rates.

Analysis of a developed Brayton cycled CHP system using ORC and CAES based on first and second law of thermodynamics

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Comparative study of two novel micro-CCHP systems based on organic Rankine cycle and Kalina cycle

Thermoeconomic analysis and multiobjective optimization of a combined gas turbine, steam, and organic Rankine cycle

Thermodynamic feasibility and multiobjective optimization of a closed Brayton cycle-based clean cogeneration system

A 3E analysis of a multi‐power generation system employing CO2, LNG, and Organic Rankine cycles

Novel geothermal driven CCHP systems integrating ejector transcritical CO2 and Rankine cycles: Thermodynamic modeling and parametric study

Performance Analysis of a New Cogeneration System with Efficient Utilization of Waste Heat Resources and Energy Conversion Capabilities

Exergo–Economic and Parametric Analysis of Waste Heat Recovery from Taji Gas Turbines Power Plant Using Rankine Cycle and Organic Rankine Cycle

Thermodynamic and exergoeconomic analyses and performance assessment of a new configuration of a combined cooling and power generation system based on ORC–VCR

Thermal Energy Recovery from a Brayton Cycle Nuclear Power Plant for Efficiency Improvement Via Compressor Inlet Cooling: Thermoeconomic Optimization

Thermodynamic analyses and optimization of a novel CCHP system integrated organic Rankine cycle and solar thermal utilization

Thermodynamic and Economic Optimization of a Double-Pressure Organic Rankine Cycle Driven by Low-Temperature Heat Source

Performance Analysis and Optimization of a Combined Cooling and Power System Using Low Boiling Point Working Fluid Driven by Engine Waste Heat

Thermoeconomic analysis of a novel cogeneration system for cascade recovery of waste heat from exhaust flue gases

Thermodynamic Analysis and Optimization of a Novel Organic Rankine Cycle-Based Micro-Scale Cogeneration System Using Biomass Fuel

Design and Analysis of the Combined Cycle With the Micro Gas Turbine and Organic Rankine Cycle Settings

Development and performance assessment of a novel combined power system integrating a supercritical carbon dioxide Brayton cycle with an absorption heat transformer

Off-design Behavior Investigation of the Combined Supercritical CO2 and Organic Rankine Cycle

Comprehensive Analysis and Optimization for a Novel Combined Heating and Power System Based on Self-Condensing Transcritical CO2 Rankine Cycle Driven by Geothermal Energy from Thermodynamic, Exergoeconomic and Exergoenvironmental Aspects

Thermodynamic Analysis Of Organic Rankine Cycle (Orc) Systems Based On Turbine Performance Prediction