Abstract:Instantaneous frequency (IF) of shaft rotation is pivotal for bearing fault diagnosis under variable speed operations. However, shaft IF cannot always be measured as tachometers are not allowed to be installed in every case due to design reasons and cost concerns. Extracting the shaft IF ridge from time frequency representation (TFR) of vibration signals, therefore, becomes an alternative. Linear transform (LT), such as short time Fourier transform (STFT), has been widely adopted for such a purpose. Nevertheless, the accuracy of extracted IF ridges relies on the readability of TFR. Unfortunately, readability of TFR from STFT is often impaired by the smearing effect caused by non-synchronous frequencies between bases and signal components and limited time frequency resolution capability, which in turn adversely influences the accuracy of IF ridge extraction. To accurately extract IF ridges from vibration signals, this paper focuses on the first factor, which causes the smearing problem, and proposes a method named frequency matching linear transform (FMLT) to enhance the TFR, where transforming bases with frequencies varying with the shaft IF are constructed to alleviate the smearing effects. To construct the transforming bases with frequencies synchronous with shaft IF, a fast path optimization (FPO) algorithm, which generates all possible optimization paths among amplitude peaks and thereby ensures the continuity of extracted IF ridges, is adopted for IF pre-estimation. The TFR with improved readability can be subsequently obtained via FMLT, paving the way for accurate IF ridge extraction. Then, multiple IF ridges can be iteratively extracted using the FPO algorithm. The accuracy of extracted IF ridges before and after TFR enhancement is compared, indicating that the proposed FMLT can enhance the readability of TFR and lead to more accurate IF ridge extraction for bearing condition monitoring.

Adaptive Cost Function Ridge Estimation for Rolling Bearing Fault Diagnosis Under Variable Speed Conditions

High-accuracy Fault Feature Extraction for Rolling Bearings under Time-Varying Speed Conditions Using an Iterative Envelope-Tracking Filter

Bearing fault diagnosis under variable speed conditions on Adaptive time frequency extraction mode decomposition

Fault Diagnosis for Rolling Bearings under Unknown Time-Varying Speed Conditions with Sparse Representation

Sparse and Low-Rank Decomposition of the Time–frequency Representation for Bearing Fault Diagnosis under Variable Speed Conditions

An Instantaneous Frequency Optimization Strategy for Bearing Fault Diagnosis under Varying Speed Conditions

An improved tracking method of bearing characteristic frequencies in the time-frequency representation of vibration signal

Rolling Bearing Weak Fault Feature Extraction under Variable Speed Conditions via Joint Sparsity and Low-Rankness in the Cyclic Order-Frequency Domain

A Novel Method for Bearing Fault Diagnosis under Variable Speed Based on Envelope Spectrum Fault Characteristic Frequency Band Identification

Time-Varying Demodulation Analysis for Rolling Bearing Fault Diagnosis under Variable Speed Conditions

Bearing fault diagnosis based on improved cepstrum under variable speed condition

Fault diagnosis of rolling bearing under a variable rotational speed and gear vibration noise based on revised ANC algorithm and FCO spectrum

Fast EEMD Based AM-Correntropy Matrix and Its Application on Roller Bearing Fault Diagnosis

Vibration Health Monitoring of Rolling Bearings under Variable Speed Conditions by Novel Demodulation Technique

An Adaptive and Tacholess Order Analysis Method Based on Enhanced Empirical Wavelet Transform for Fault Detection of Bearings with Varying Speeds

Time Frequency Representation Enhancement via Frequency Matching Linear Transform for Bearing Condition Monitoring under Variable Speeds

Bearing Condition Monitoring Via Multiple Instantaneous Frequency Path Extraction from Enhanced Time Frequency Representation

Rolling Element Bearing Fault Diagnosis Via Fault Characteristic Order (FCO) Analysis

A Fast and Adaptive Varying-Scale Morphological Analysis Method for Rolling Element Bearing Fault Diagnosis

Rolling Element Bearing Instantaneous Rotational Frequency Estimation Based on EMD Soft-Thresholding Denoising and Instantaneous Fault Characteristic Frequency

Two-Step Adaptive Chirp Mode Decomposition for Time-Varying Bearing Fault Diagnosis