Abstract:The development of smart Internet-of-Things (IoT) solutions requires sensor nodes to be placed at different locations of monitored structures. Wireless solutions are quite attractive because of their simplicity although requiring for local energy supply. In this context, this study investigates the influences of the predefined angle of attack on the piezoelectric energy harvesting based on transverse galloping of different bluff bodies. The investigation is based on a lumped electro-aero-mechanical model with linear electrical and mechanical properties and nonlinear aerodynamic forces evaluated using the quasi-steady theory. The performances of energy harvesters with six different bluff bodies are analyzed at various predefined angles of attack: four rectangular cross-sections with different width-to-height ratios (i.e., b/d), one trapezium section, and one equal angle section. The main purpose is to understand the sensitivity of various bluff body-based energy harvesters on the predefined angle of attack, and further suggest a bluff body-based energy harvester that is robust to the predefined angle of attack. The results show that the response is quite dependent on the characteristic of the electro-mechanical system and the bluff body cross-section and angle of attack. In all cases, the load resistance should be tuned to maximize energy production. The largest vibration amplitude (i.e., largest power output) is predicted for the rectangular bluff body with b/d = 1.0 at a 0 degrees angle of attack. However, its performances are quite dependent on the angle of attack, resulting in a zero-power output for an angle of attack exceeding 4 degrees. A rectangular bluff body with b/d within 1.62 to 2.5 exhibits a reduced energy production compared with b/d = 1.0 at a 0 degrees angle of attack but better robustness varying the angle of attack. Finally, the trapezium and the angle bluff bodies are not suitable for energy harvesting due to their very high onset velocities within the considered range of angles of attack.

Y-type three-blade bluff body for wind energy harvesting

Influence of Predefined Angle of Attack on Piezoelectric Energy Harvesting from Transverse Galloping of Different Bluff Bodies

Low-Wind-Speed Galloping Wind Energy Harvester Based on a W-Shaped Bluff Body

Fork-shaped bluff body for enhancing the performance of galloping-based wind energy harvester

An enhanced galloping-based piezoelectric energy harvester with non-rotational bluff body

A Hybrid Flapping-Blade Wind Energy Harvester Based on Vortex Shedding Effect

Enhancement of low-speed piezoelectric wind energy harvesting by bluff body shapes: Spindle-like and butterfly-like cross-sections

A wind-direction adaptive piezoelectric energy harvester employing small wing passive control configuration

Piezoelectric Galloping Energy Harvesting Enhanced by Topological Equivalent Aerodynamic Design

Performance enhancement of wind energy harvester utilizing wake flow induced by double upstream flat-plates

An Innovative V-shaped Piezoelectric Energy Harvester for Wind Energy Based on the Fully Fluid-Solid-electric Coupling

Enhancing output performance of galloping-based energy harvesting using asymmetric bluff body

Experimental Investigation of Three-Dimensional Multi-Directional Piezoelectric Wind Energy Harvester

Piezoelectric energy harvesting from hybrid vibrations

A piezoelectric energy harvester with a hybrid nonlinearity of bluff body and magnet repulsion in low threshold wind speed for power supply

Nonlinear Analysis of Piezoelectric Wind Energy Harvesters with Different Geometrical Shapes

Prototyping and Electromagnetic Analysis of a Biaxial-Pendulum Wave Energy Harvester

A hybrid piezo-dielectric wind energy harvester for high-performance vortex-induced vibration energy harvesting

A U-shaped multi-modal bi-directional piezoelectric energy harvester

Improving the performance of galloping energy harvester with striped bluff body

Performance enhancement of galloping wind energy harvesting via bio-inspired V-shaped blade