Abstract:The development of smart Internet-of-Things (IoT) solutions requires sensor nodes to be placed at different locations of monitored structures. Wireless solutions are quite attractive because of their simplicity although requiring for local energy supply. In this context, this study investigates the influences of the predefined angle of attack on the piezoelectric energy harvesting based on transverse galloping of different bluff bodies. The investigation is based on a lumped electro-aero-mechanical model with linear electrical and mechanical properties and nonlinear aerodynamic forces evaluated using the quasi-steady theory. The performances of energy harvesters with six different bluff bodies are analyzed at various predefined angles of attack: four rectangular cross-sections with different width-to-height ratios (i.e., b/d), one trapezium section, and one equal angle section. The main purpose is to understand the sensitivity of various bluff body-based energy harvesters on the predefined angle of attack, and further suggest a bluff body-based energy harvester that is robust to the predefined angle of attack. The results show that the response is quite dependent on the characteristic of the electro-mechanical system and the bluff body cross-section and angle of attack. In all cases, the load resistance should be tuned to maximize energy production. The largest vibration amplitude (i.e., largest power output) is predicted for the rectangular bluff body with b/d = 1.0 at a 0 degrees angle of attack. However, its performances are quite dependent on the angle of attack, resulting in a zero-power output for an angle of attack exceeding 4 degrees. A rectangular bluff body with b/d within 1.62 to 2.5 exhibits a reduced energy production compared with b/d = 1.0 at a 0 degrees angle of attack but better robustness varying the angle of attack. Finally, the trapezium and the angle bluff bodies are not suitable for energy harvesting due to their very high onset velocities within the considered range of angles of attack.

Fork-shaped bluff body for enhancing the performance of galloping-based wind energy harvester

Influence of Predefined Angle of Attack on Piezoelectric Energy Harvesting from Transverse Galloping of Different Bluff Bodies

Low-Wind-Speed Galloping Wind Energy Harvester Based on a W-Shaped Bluff Body

An enhanced galloping-based piezoelectric energy harvester with non-rotational bluff body

Enhancement of low-speed piezoelectric wind energy harvesting by bluff body shapes: Spindle-like and butterfly-like cross-sections

Y-type three-blade bluff body for wind energy harvesting

Performance enhancement of wind energy harvester utilizing wake flow induced by double upstream flat-plates

Piezoelectric Galloping Energy Harvesting Enhanced by Topological Equivalent Aerodynamic Design

Enhancing output performance of galloping-based energy harvesting using asymmetric bluff body

Performance enhancement of galloping wind energy harvesting via bio-inspired V-shaped blade

Improving the performance of galloping energy harvester with striped bluff body

An Innovative V-shaped Piezoelectric Energy Harvester for Wind Energy Based on the Fully Fluid-Solid-electric Coupling

Piezoelectric energy harvesting from hybrid vibrations

Multi-interference local pressure modulation for improving performance of piezoelectric wind energy harvesters

A downwind-vibrating piezoelectric energy harvester under the disturbance of a downstream baffle

Improving the wind energy harvesting performance with double upstream fractal bluff bodies

A hybrid piezo-dielectric wind energy harvester for high-performance vortex-induced vibration energy harvesting

A wind-direction adaptive piezoelectric energy harvester employing small wing passive control configuration

Performance analysis of galloping-based piezoaeroelastic energy harvesters with different cross-section geometries

Nonlinear Analysis of Piezoelectric Energy Harvesters from Ambient and Galloping Vibrations

Novel optimization strategy of a flow-induced piezoelectric vibration-based energy harvesting structure