Abstract:The flow reversal (FR) technique consists of reversing the flow direction along a chromatographic column. It is used to reveal the origin (such as poor column packing, active sites, or slow absorption/escape kinetics) for the resolution limit of 4.6 mm × 150 mm long columns packed with 1.7 μm 200 Å Bridge-Ethylene-Hybrid (BEHTM) Particles. These columns are used to separate manufactured monoclonal antibodies (mAb, ∼ 150 kDa) from their close impurities (or IdeS fragments, ∼ 100 kDa) by size exclusion chromatography (SEC). FR unambiguously demonstrates that the resolution limit of these SEC columns is primarily due to long-range flow velocity biases covering distances of at least 500 μm across the column diameter. This confirms the existence of center-to-wall flow heterogeneities which cause undesirable tailing for the mAb peak. Because the transverse dispersion coefficient (Dt=1.1 × 10-6 cm2/s) of mAbs across the column diameter is intrinsically low, the bandspreading of the mAb in a single flow direction is in part reversible upon reversing the flow direction. For the very same residence time in the column, the column efficiency is found to increase by +85% relative to that observed under conventional elution mode. The observed peak tailing of the mAb and its sub-units is not caused by active surface sites or by slow absorption/escape from the BEH Particles. Therefore, the most critical mAb impurities (hydrolytic degradation Fab/c and IdeS [Formula: see text] fragments) can only be successfully separated and quantified with acceptable accuracy by adopting alternate pumping recycling liquid chromatography (APRLC). APRLC enables the full baseline separation of the mAb and 100 kDa mAb fragments and partial separation of Fab/c and [Formula: see text] fragments after increasing the number of cycles to ten. It was made possible to accurately measure the relative abundances of the mAb (99.0 ± 0.1%), [Formula: see text] fragment (0.88 ± 0.03%), and Fab/c immunogenic fragment (0.13 ± 0.02%) in less than 45 min for a total mAb sample load of only 5 μg. Still, further improvements are needed to increase the sensitivity of the APRLC method and to reduce the solvent consumption by adopting narrow-bore 2.1 mm i.d. SEC columns.

Comparison of membrane chromatography devices in laboratory-scale preparative flow-through separation of a recombinant protein

High-Throughput Process Development for Recombinant Human Serum Albumin Separation from Pichia Pastoris Broth with Mixed-Mode Chromatography

Process design and application of twin-column continuous chromatography for antibody affinity separation

Analysis and Optimal Design of Batch and Two‐column Continuous Chromatographic Frontal Processes for Monoclonal Antibody Purification

High-throughput screening methods for protein adsorption evaluation with microtiter filter plate

Analysis and Optimal Design of Batch and Two-Column Continuous Chromatographic Frontal Processes for Monoclonal Antibody Purification

Two-step Separation Strategy with Mixed-Mode Chromatography to Purify Recombinant Human Serum Albumin from Pichia Pastoris Culture Broth

Improving the Operating Conditions of Gradient Ion-Exchange Simulated Moving Bed for Protein Separation

A high-throughput approach to developing and optimizing mixed-mode membrane chromatography for protein purification

Assessment of membrane-based downstream purification processes as a replacement to traditional resin bead for monoclonal antibody purification

A Carrier Phase Ultrafiltration and Backflow Recovery Technique for Purification of Biological Macromolecules

Comparison of batch and continuous multi-column capture of monoclonal antibodies with convective diffusive membrane adsorbers

Application of Confocal Laser Scanning Microscopy in Bioseparation Studies: Visual Characterization of Protein Adsorption Behaviors

Continuous Separation of Proteins by Multichannel Flow Electrophoresis

Resolution limits of size exclusion chromatography columns identified from flow reversal and overcome by recycling liquid chromatography to improve the characterization of manufactured monoclonal antibodies

Optimization of fluid flow in membrane chromatography devices using computational fluid dynamic simulations

Characterization of a biopharmaceutical protein and evaluation of its purification process using automated capillary Western blot

Protein Band Dispersion in Axial and Radial Flow Chromatography

Performance of hollow-fiber flow field-flow fractionation in protein separation

A comprehensive method for modeling and simulating ion exchange chromatography of complex mixtures

A tandem laboratory scale protein purification process using Protein A affinity and anion exchange chromatography operated in a weak partitioning mode