Abstract:Nowadays, ventilation ducts, especially duct bends, play a significant role in filtering aerosol contaminant for the built environment. This article experimentally investigates practical averaged aerosol deposition in 90° ventilated bends of rectangular cross section by measuring particle concentration changes at bend inlet and outlet in steady state. The measured penetrations at Reynolds number Re = 17,900 and 35,600 are in good agreement with previously published data at small Stokes number, which justifies the effectiveness of the measurement process. Particle penetration decreases from approximately 100% for St = 5.2 × 10−4 particles to 64% for St = 0.55 particles in acrylic glass bends. For the particles of Stokes number larger than 0.089, particle penetration is much higher than that in previous studies. This behavior is believed to be caused by the consideration of particle rebounce from bend wall in the presence of centrifugal force. The changes in Reynolds number do not significantly alter the trend of deposition velocity and penetration. Deposition velocities are compared and verified with available droplet data and current numerical and analytical analysis. For the high deposition velocity increase compared to that in straight ducts, the major mechanism is attributed to the flow impaction onto outer bend wall. In this type of bend, secondary flows and streamwise eddies provide a further reason for distinct deposition increase of small particles. In a word, the deposition mechanisms are analyzed analytically and systematically, and then classified in order clearly. In addition, two empirical models were proposed in this article, which are valid for Stokes number St = 5.2 × 10−4–0.55 under the experimental conditions. Copyright 2013 American Association for Aerosol Research

Numerical study of particle deposition in turbulent duct flow with a forward- or backward-facing step

Effects of blockage ratio and Reynolds number on particle deposition in duct airflow over a forward-facing step

Particle Deposition Characteristics And Efficiency In Duct Air Flow Over A Backward-Facing Step: Analysis Of Influencing Factors

Numerical simulation of gas–particle dispersion in a backward-facing step flow with LES–FDF model

CFD simulation of particle deposition in a horizontal turbulent duct flow

Effects of Finite-Size Heavy Particles on the Turbulent Flows in a Square Duct

Modeling particle deposition onto rough walls in ventilation duct

Simulation of Turbulent Flow Structure and Particle Deposition in a Three-Dimensional Heat Transfer Duct with Convex Dimples

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Investigation of particle deposition efficiency enhancement in turbulent duct air flow by surface ribs with hybrid-size ribs

Study on particle deposition in ventilation ducts

Numerical investigation on monodispersed particle deposition in turbulent duct flow with thermophoresis

Modeling particle deposition from fully developed turbulent flow in ventilation duct

Numerical Simulation of Turbulent Structure and Particle Deposition in a Three-Dimensional Heat Transfer Pipe with Corrugation

Particle deposition in turbulent duct flows—comparisons of different model predictions

Experimental Study of Solid Particle Deposition in 90° Ventilated Bends of Rectangular Cross Section with Turbulent Flow

Effect of Drag Force on Backward-Facing Step Gas-Particle Turbulent Flows

Numerical analysis of particle deposition in ventilation duct

A numerical simulation of particle deposition in turbulent boundary layers

Numerical simulation of turbulent flow and particle deposition in heat transfer channels with concave dimples

Numerical study of deposition rates of monodisperse particles in curved pipes with different expansion or shrinkage variables