Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In the present work, the process chain in tube production by roll forming of the steel 34MnB5 was examined in more detail. The process chain consisting of the steps (i) roll forming, (ii) HFI welding, and then (iii) straightening and final calibration was mapped using the finite element method. In addition to the pipe geometry, the residual stress distribution was considered as an essential target value for the assessment of the performance of the tubes under service conditions. The objective of the project is to describe the manufacturing process and thus the processing induced residual stress distributions as realistically as possible. For a more detailed characterization of the process and above all for the validation of the numerical simulations, experimental residual stress analyses were carried out for the final state of the tubes using complementary analysis methods. The contour method was used to determine the 2D-distribution of residual stresses across the transverse and longitudinal sections of the manufactured pipes. These measurements were supplemented by local residual stress analyses using the incremental hole drilling method and X-ray residual stress analyses. The work thus pursues both a methodical approach to the analysis of the internal stresses induced by the process using complementary methods and also a manufacturing approach to the analysis and evaluation of the production chain. In particular for the axial components of the residual stresses, it can be shown that experimentally determined residual stresses correlate well with the numerically calculated values. The contour method is excellently suited to monitor the uneven distribution of the internal stresses over the pipe cross-section. The results of the simulation show that the overall residual stress distribution that is determined using the contour method mainly results from the plastic strains introduced by the roll forming process. X-ray and hole drilling analyses are shown to be more suitable for measuring locally present residual stresses at defined positions on the outer tube surface. In this way it can be shown that the simulation approach described provides an accurate model of the process.

Numerical Simulation of JCO-E Pipe Manufacturing Process and Its Effect on the External Pressure Capacity of the Pipe1

Numerical Simulation on Dynamic Behaviour of Deepwater J-lay Systems

Buckling Response of Offshore Pipelines under Combined Tension, Bending, and External Pressure

Simulation and Analysis of UOE Pipe Production Processing by Three-Dimensional Finite Element Method

Theoretical Analysis and Numerical Simulation of Large-Diameter and Thin-Wall Pipelines During Ultra-Deep J-Lay Installation

Buckling Response of Offshore Pipelines under Combined Tension and Bending

Numerical Simulation and Experimental Confirmation of a Bimetallic Pipe Forming Process

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

Integrated finite element simulation and experiment verification of the large-sized straight welded pipe processing with JCOE technology

Collapse Resistance Under Combined External Pressure and Bending Deformation of Coated Linepipe

On Elastic-Plastic Collapse of Subsea Pipelines under External Hydrostatic Pressure and Denting Force

Asymmetric buckling of offshore pipelines under combined tension, bending and external pressure

Configuration Analysis of Deepwater S-Lay Pipeline

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Asymmetric Collapse of Offshore Pipelines under External Pressure

Numerical Analysis of Pipeline in J-Lay Problem

Dynamic Responses of Jacket Foundation Offshore Wind Turbine Considering the Cyclic Loading Effects

Parametric study on the mechanical behavior of submarine pipeline for deepwater S-lay operation

Experimental and numerical analysis of residual stresses induced by the manufacturing process of longitudinal welded tubes

The research on pipe structural behavior of 3D UOE manufacturing process