Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Design of Inducer-Impeller Configurations of Self-Priming Vacuum Pump Using Response Surface Method

Rotating Cavitation of the High-Speed Rotational Inducer of LPRE

Study on performance and structure optimization of self-priming pump based on response surface method

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Improvement Design of a Vertical Double-stage Self-priming Pump

Response surface method‐based hydraulic performance optimization of a single‐stage centrifugal pump

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Research on Cavitation Characteristic of Inducer

Performance improvement of the sanitary centrifugal pump through an integrated approach based on response surface methodology, multi-objective optimization and CFD

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Optimization of a Centrifugal Impeller on Blade Thickness Distribution to Reduce Hydro-Induced Vibration

Design optimization for mixed-flow pump impeller by improved suction performance and efficiency with variables of specific speeds

Optimization Design on Performance of Self-Priming Jet Pump Based on Orthogonal Test

Optimization Design for an Impeller of the Multiphase Rotodynamic Pump Handling Gas-Liquid Two-Phase Flow

Multifactor response-based optimization for enhancing cavitation performance of short injection self-priming pumps

Design Technology of Centrifugal Fan Impeller Based on Response Surface Methodology

Optimization of cavitation performance and hydraulic performance of multistage pump based on response surface method

Numerical study on hydraulic and self-priming performance of a double-stage self-priming pump

Investigation of Self-Priming Process of a Centrifugal Pump with Double Blades

Design Methodology and Performance Analysis of Conical Rotors for Dry Screw Vacuum Pumps

Liquid hydrogen centrifugal pump optimization based on reducing hydraulic loss and improving cavitation