Abstract:In this study, a thermo-mechanical finite element model was developed to investigate the thermal deformation during a stamping process of an automotive body part. The stamping process was decomposed into the 6 sub-steps to reflect the physical boundary conditions found in an actual stamping equipment. The temperature distributions of the actual stamping process were measured by two thermography cameras. The developed numerical procedure was then validated against the measured temperature distributions. Due to the limited accessibility to the actual equipment and high reflectivity of the involved material, the reflectivity index for the thermal imaging device (i.e., emissivity) was experimentally determined. A sample specimen made of the same material with the die material was built. The thermocouples were placed underneath the specimen surface through holes and used to directly measure the surface temperature distribution. The emissivity for the sample specimen was then determined by comparing the temperature measured by the thermocouples to the temperature measured by the thermographic camera. When the lubrication oils were spread on the sample specimen, the emissivity was set to a value 0.7. The thermal images were corrected based on the emissivity experimentally obtained and used to validate the finite element model simulation for the stamping process. With the validated finite element model, the investigation on the variation in the temperature and stress during each sub-step was performed. With the zero thermal expansion rate, the pure thermal effect on the temperature distribution was simulated. The pure thermal deformation in the Blank (i.e., target surface) was similar to the spring back distance after the blank was released from the molds. During the stamping process, the heat generation was obtained due to either friction between surfaces and plastic deformation of the target surface. We found that the plastic deformation played a critical role in the final temperature rise.

Thermomechanical simulations of blanking process operated over a wide range of punch velocities

Numerical simulation and optimization of process parameters in fineblanking process

Simulation Analysis of Upper Mould Base for High Speed Punch

Numerical simulation of fine-blanking process using a mixed finite element method

Accuracy of Modified Johnson–Cook Modelling of the Blanking Process through Experimental and Numerical Analysis

A Study of Fine Blanking Process by Fem Simulation

Fine-blanking Process Simulation by Rigid Viscous-Plastic FEM Coupled with Void Damage

Finite Element Simulation For Blanking Process Of Sheet Metal

Ductile Damage and Simulation of Fine-Blanking Process by FEM

Analysis of Sheared Edge Quality in Rotary Blanking Process Based on Lemaitre Damage Model

Ductile Fracture Modeling of Initiation and Propagation in Sheet-Metal Blanking Processes

Numerical Simulation of Sheet Metal Blanking Based on Fully Coupled Elastoplasticity-Damage Constitutive Equations Accounting for Yield Surface Distortion-Induced Anisotropy

Evaluation Of The Sheared Edge Of The Metal Blanking Process With One Ductile Damage Model Combined The Induced Anisotropy

Sheet Metal Blanking Modeling Using Lode-Dependent Plasticity and Ductile Damage Models Combined with 3D Adaptive Remeshing Method

Numerical Simulation on Edge Crack of Advanced High-Strength Steel Considering Blanking Induced Damage

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Numerical Investigation of the Damage Effect on the Evolution of Adiabatic Shear Banding and Its Transition to Fracture during High-Speed Blanking of 304 Stainless Steel Sheets

An Investigation of Step-Shaped-punch Fine-Blanking Process Using Finite Element Method

Investigation on Ductile Fracture in Fine-Blanking Process by Finite Element Method

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

Numerical modeling of the thermal deformation during stamping process of an automotive body part