Abstract:Ultra-high performance concrete (UHPC) is characterized by its ultra-high strength and durability, making it suitable for use in large-span bridges, super high-rise buildings, and other special structures. These types of structures often have high requirements for crack control, making the exploration of UHPC's fracture mechanics properties of significant importance. Therefore, this paper sets up four steel fiber contents (0%, 0.6%, 1.2% and 1.8%) and four strain rates (10-5/s, 10-4/s, 10-3/s and 10-2/s), totaling 16 working conditions. The hydraulic servo system combined with digital image correlation (DIC) technology was used to conduct fracture mechanics tests on UHPC three-point bending beams. The test results show that the unstable fracture load of UHPC increases with the increase of strain rate and steel fiber content, and increasing the steel fiber content can enhance the strain rate effect of UHPC to a certain extent. Additionally, combined with the J-criterion model, this study proposed a dynamic criterion for the unstable fracture load of UHPC considering the influence of steel fiber content. The initial fracture toughness, unstable fracture toughness, and fracture energy of UHPC are significantly more affected by steel fiber content than by strain rate. Through DIC technology, the analysis of UHPC crack propagation shows that UHPC without steel fibers experiences rapid crack expansion in the Pre-90% to Peak stage, with less influence from the strain rate. However, UHPC with steel fibers exhibits a more uniform crack growth rate, with the crack emergence phase gradually lagging as the strain rate increases. For UHPC without steel fibers, the crack opening displacement (COD) at the unstable fracture load point surges suddenly, while the COD development in UHPC with steel fibers is slower. At lower strain rates, an increase in steel fiber content leads to an earlier sudden increase phase in UHPC's COD; at higher strain rates, the influence of steel fiber content on the sudden increase phase of UHPC's COD is more scattered. The research results of this paper provide a theoretical basis for the calculation and analysis of the dynamic response of UHPC structures under seismic loads.

Numerical investigation of the dynamic increase factor of ultra-high performance concrete based on SHPB technology

Compressive Impact Tests of Lightweight Concrete with 155-Mm-diameter Spilt Hopkinson Pressure Bar

High-strain Rate Compressive Behavior of CFRP Confined Concrete: Large Diameter SHPB Tests

Effect of Fiber Content and Fiber Length on the Dynamic Compressive Properties of Strain-Hardening Ultra-High Performance Concrete

Study of dynamic mechanical properties of UHPC-AAC composites based on SHPB test

Evaluation of typical dynamic damage models used for UHPC based on SHPB technology

Study on dynamic properties of lightweight ultra-high performance concrete (L-UHPC)

Study on the Dynamic Mechanical Properties of Ultrahigh-Performance Concrete under Triaxial Constraints

Dynamic increase factor(DIF) of concrete with SHPB tests: Review and systematic analysis

Study on Dynamic Impact Mechanical Properties of UHPC with High-Content and Directional Reinforced Steel Fiber

Dynamic Compressive Mechanical Properties of UR50 Ultra-Early-Strength Cement-Based Concrete Material under High Strain Rate on SHPB Test

Direct tensile behavior of steel fiber reinforced ultra-high performance concrete at high strain rates using modified split Hopkinson tension bar

Numerical investigation of the failure mechanism of cubic concrete specimens in SHPB tests

Drop-Weight Impact Resistance of Ultrahigh-Performance Concrete and the Corresponding Statistical Analysis

Study on the Dynamic Fracture Mechanical Properties of Ultra High-Performance Concrete under the Influence of Steel Fiber Content

Research on Dynamic Strength and Inertia Effect of Concrete Materials Based on Large-Diameter Split Hopkinson Pressure Bar Test

Numerical study of the influences of pressure confinement on high-speed impact tests of dynamic material properties of concrete

Experimental, Numerical, and Analytical Studies of Uniaxial Compressive Behavior of Concrete Confined by Ultra-High-Performance Concrete

Experimental and numerical investigations on direct shear performance of UHPC dry joints

A novel dynamic constitutive model for UHPC under projectile impact

Numerical study on the mechanical behavior of ultrahigh performance concrete using a three‐phase discrete element model