Abstract:Supported reagents have been widely used in organic synthesis for some 25 years and their importance is likely to increase as a result of new environmental legislation and the drive towards clean technology. While many supported reagents are stoichiometric in reactions the successful development of genuinely catalytic materials greatly enhances their value especially in liquid phase, typically fine chemical syntheses. Achieving an understanding of the nature of these fascinating materials is also an important aspect of their development and is essential if their true potential is to be realised. Solid acids are the most widely studied of supported reagents and their use as more environmentally acceptable replacements for conventional Bronsted and Lewis acids is likely to become increasingly important. Clayzic is a good example of an environmentally friendly catalyst with particular value as an alternative to the hazardous reagent aluminium chloride in Friedel-Crafts reactions. The structure and properties of this catalyst are, however, poorly understood. X-Ray diffraction studies show that thermal treatment of either clayzic or its base material K10 results in the loss of any montmorillonite crystallinity that remained after the acid treatment of tonsil 13 used to form K10. Thermal treatment of clayzic also results in a steady increase in the surface area of the material. While this is also consistent with structural changes the increase is also likely to be partly due to the dehydration allowing the non-polar adsorbate to enter more of the polar regions of the material. These polar regions can be identified as mesopores created by the acid treatment of the clay and in which the zinc ions largely reside. Spectroscopic titration of the acid sites in clayzic show these to be largely Lewis acid in character. Thus clayzic owes its remarkable Friedel-Crafts activity to the presence of high local concentrations of zinc ions in structural mesopores. Relative reaction rates for the clayzic catalysed benzylation of alkylbenzenes also reveal the importance of these highly polar mesopores. Considerable rate enhancements can be achieved by thermally activating the catalyst and this can be largely attributed to the dehydration of the catalyst enabling better partitioning of the alkylbenzenes into the mesopores. Clayzic can be considered as being a large pore molecular sieve but where the sieving of molecules is controlled more by molecular polarities/polarisibilities than by molecular shape.

Synthesis and characterization of an efficient and stable Al/Fe pillared clay catalyst for the catalytic wet air oxidation of phenol

Pillared interlayered clays as catalyst for wastewater treatment: Cost-effective and sustainable materials

Synthesis and Characterization of Aluminum and Al/REE Pillared Clays and Supported Palladium Catalysts for Benzene Oxidation

Thermally Stable Metal(Cu, Fe)-Substituted Mesoporous Aluminophosphates: Synthesis and Application As Oxidation Catalysts

Catalytic oxidative degradation of paracetamol in water solutions over Al/Fe -pillared clay

Pillared Clay-Supported Noble Metal And Metal Oxide Catalysts For Complete Oxidation Of Vocs

Synthesis and characterization of hydroxy-CrAl pillared clays

Preparation of manganese-impregnated alumina-pillared bentonite, characterization and catalytic oxidation of CO

Restructuring of silica-pillared clay (SPC) through posthydrothermal treatment and application as phosphotungstic acid supports for cyclohexene oxidation

TiO2/Al-PILC Catalysts Synthesized from a Non-Conventional Aluminum Source of Aluminum and Applied in the Photodegradation of Organic Compounds

Synthesis of polymer-supported porphyrinatoiron and its application for catalytic oxidation of cyclohexane.

An atom-economic reaction for synthesis of 1-phenoxy-2-propanol over Al2O3/MgO

Hydroxyl-aluminum pillared bentonite enhanced Mn(II) removal by chlorine oxidation

Preparation and Characterization of Hydroxysilicoaluminum Pillared Clays

Influence of synthesis condition on pore structure of Al pillared clays and supported Pd catalysts for deep oxidation of benzene

Catalytic Performance of Pillared Interlayered Clays (pilcs) Supported CrCe Catalysts for Deep Oxidation of Nitrogen-Containing VOCs

Preparation and Characterization of Hydroxy-Feal Pillared Clays

Keynote Article. Environmentally Friendly Chemistry Using Supported Reagent Catalysts: Structure–property Relationships for Clayzic

Covalent bonding of N‐hydroxyphthalimide on mesoporous silica for catalytic aerobic oxidation of p‐xylene at atmospheric pressure

Preparation,Characterization and Surface Acidity of Hydroxy-Fe-Al Pillared Clays Containing Mixed-matal Complexes(II)

Environment-friendly heterogeneous poly(ionic liquid)s immobilized polyoxometalate catalysts towards the efficient oxidation of alkenes