Abstract:The green wave coordinated control model has evolved from the basic bandwidth maximization model to the multiweight approach to an asymmetrical multiband model and a general signal progression model with phase optimization to improve the operational efficiency of urban arterial roads and reduce driving delays and the amount of exhaust gas generated by vehicles queuing at intersections. However, most of the existing green wave models of arterial roads are based on a single phase pattern and little consider the optimization of the combination of multiple phase patterns. Initial queue clearing time is also considered at the green wave progression line in the time–space diagram, which leads to a waste of green light time. This study proposes a coordination control optimization method based on an asymmetrical multiband model with phase optimization to address the abovementioned problem. This model optimizes four aspects in the time–distance diagram: phase pattern selection, phase sequence, offset, and queue clearing time. Numerical experiments were conducted using the VISSIM micro traffic simulation tool for intersections along Kunlunshan South Road in Qingdao, and the effect of green wave coordination was evaluated using hierarchical analysis and compared with the signal-timing schemes generated by the four models: the multiweight approach, the improved multiweight approach, an asymmetrical multiband model, and a general signal progression model with phase optimization. The results show that an asymmetrical multiband model with phase optimization obtains a total bandwidth of 314 s in both directions. In the outbound direction, average number of stops, average travel speed, average travel time, and average delay time improve by 16%, 7.9%, 17.9%, and 15.6%, respectively. In the inbound direction, they improve by 43.7%, 16.1%, 40.7%, and 36%, respectively. Polluting gas emissions and fuel consumption improve by 17.9%. The applicability of the optimization method under different traffic flow conditions is analyzed, and results indicate a clear control effect when the traffic volume is moderate and the turning vehicles on the feeder roads are few. This work can provide a reference for the optimization of subsequent arterial signal coordination and also has indirect significance for environmental protection to a certain extent.

Optimization Control of Motor Vehicle at Intersection Based on Green Building Materials

A Green Wave Band Based Method for Urban Arterial Signal Control

Traffic Signal Control Optimization Strategy Based on Simulation

Isolated intersection control based on hybrid optimization model

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

A Semi-"Smart Predict, then Optimize" Method for Traffic Signal Control.

Optimization of Urban Road Intersection Based on VISSIM Simulation Software

A Green Driving Speed Control Method at Signal Intersection

Optimization control of urban intersection based on vehicle flow cost model

Design of an Intelligent Traffic Controller Based on Vehicle Detection Technology

Coordination Control Strategy of Urban Expressway On-ramp and Off-ramp

Intersection multi-objective optimization on signal setting and lane assignment

Integrated optimization of traffic signals and vehicle trajectories at isolated urban intersections

Optimization method for urban intersection and empirical research from the perspective of safety

Integrating traffic signal optimization with vehicle microscopic control to reduce energy consumption in a connected and automated vehicles environment

Optimization of signalized intersection based on VISSIM-SSAM simulation

Arterial Coordination Control Optimization Based on AM–BAND–PBAND Model

Multi-objective Optimization at Isolated Intersections with Cellular Automata

Optimizing Signal Controls for Urban Mixed Use Transport Arterial

Optimization design of single intersection actuated control based on traffic priority

Human-Vehicle Intersection Traffic Lights Timing Optimization Research