Abstract:An efficient intersection signal scheme is of vital significance to urban traffic operation. At present, multiperiod fixed-timing control is still the traffic signal control method adopted by many urban intersections. For the optimization problem of signal scheme selection at signalized intersections, we proposed three two-step prediction optimization methods that match the traffic arrival in different periods with the corresponding optimal signal scheme, aimed at reducing the total delay of vehicles at signalized intersections. The first method predicts the traffic flow in each entrance direction of the intersection by minimizing the mean square error (MSE), then obtains the total vehicle delay of each scheme in the signal scheme set through the Highway Capacity Manual 2010 delay formula, and finally substitutes it into the signal optimization model to obtain the optimal scheme combination. The second method directly predicts the total vehicle delay at intersections of all signal schemes by minimizing the MSE and then substitutes it into the signal optimization model to obtain the optimal scheme combination. The third method directly predicts the total vehicle delay at intersections of all signal schemes by minimizing both the MSE and the prediction error between every two schemes and then substitutes it into the signal optimization model to obtain the optimal scheme combination. Verification based on actual intersection shows that better optimization results can be obtained by integrating optimization objectives into the prediction process. Besides, some practical insights can be drawn through applicability analysis and sensitivity analysis. First, the proposed model is more suitable for intersections where traffic arrivals vary greatly. Second, with the increase of scheme differences within a certain range, the advantages of the proposed method become more obvious. Finally, it is necessary to balance the flexibility of traffic control with control effectiveness in practical applications.

Optimization of signalized intersection based on VISSIM-SSAM simulation

Traffic Signal Control Optimization Strategy Based on Simulation

Optimization of Urban Road Intersection Based on VISSIM Simulation Software

Optimized Simulation on the Intersection Traffic Control and Organization Based on Combined Application of Simulation Softwares

Development of a Procedure for Using Surrogate Safety Assessment Model and VISSIM for Safety Assessment at Signalized Intersections

Optimization of Signal Control at Offset Intersections

Simulation Evaluation of Intersection Signal Optimal Timing Ased on Vissim

Research on optimization of signal phase at intersection based on VISSIM simulation software

Development of Traffic Safety Evaluation Method Based on Simulated Conflicts at Signalized Intersections

Maximum cycle length optimization method of signalized intersection

Traffic Conflict Simulation Analysis for Urban Road Intersection

Application of VISSIM in Signalized Intersection Optimization

A Semi-"Smart Predict, then Optimize" Method for Traffic Signal Control.

Evaluation Analysis and Optimization Design of Urban Road Traffic Condition Based on VISSIM

Evaluation and Simulation Study of Traffic at Intersection of Wuhan Heping Avenue-Jianshe No.2 Road

Optimization method for urban intersection and empirical research from the perspective of safety

Optimization Research on Unsaturated Intersections Based on Traffic Delay

Influence of signal on the capacity of signalized intersection

Calibration and Validation Procedure for Intersection Safety Simulation Using SSAM and VISSIM

Optimization Model and Simulation Analyses of Pre-timed Signals Control at Isolated Intersections

Malformed Intersection Level of Service Promotion Strategy Research Based on VISSIM