Abstract:The study confirmed that the frictional behaviour of paper‐based materials is influenced by surface topography rather than surface roughness of plates. There was no clear correlation between the surface roughness of materials, fibre orientation, calculated total surface energy and friction coefficient. However, possible correlation between the dispersion components of the surface energy and kinetic friction were observed. Thermal camera analysis proved that material stickiness on forming tube of VFFS machine can occur due to high sliding speed and contact pressure. This study evaluated the frictional behaviour of flexible polymer‐coated and dispersion‐coated materials used in vertical form–fill–seal (VFFS) machines. A laboratory‐scale friction measurement device was developed to investigate the relationship between different surface topographies, roughness and frictional properties. Furthermore, surface roughness, contact angle and surface energy of the material were analysed and a microscopic analysis was performed to further understand the effect of material properties on friction. Thermal camera analysis was performed to measure the temperature changes within the material during the film‐transport stage of the VFFS machine. The friction measurement results indicated that the sliding direction did not affect the static and kinetic coefficients of friction. The significant influence of friction on the surface topography of the plate (forming shoulder and tube) was particularly evident. Some materials experienced the stick–slip phenomenon during sliding, depending on the surface type. Teflon tape, which is commonly used in the forming tubes of VFFS machines, exhibited the lowest coefficient of friction. Thermal camera analysis revealed that polymer‐coated paper materials generated more heat than dispersion‐coated papers during VFFS trials and thermoplastic films generated the least heat. No clear relationship between the surface roughness of the paper, fibre orientation, surface energy and friction coefficient was noted. Furthermore, paper‐based materials exhibited a higher coefficient of friction, which is possibly related to the dispersion components of surface energy. The findings of this study provide additional knowledge for designing the forming tube, shoulder geometry and surface plate to minimize the occurrence of defects, such as wrinkles, in paper‐based packages.

Web lateral instability caused by nonuniform paper properties

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Rate-dependent interaction between thin films and interfaces during micro/nanoscale transfer printing

Compaction Pressure Distribution and Pressure Uniformity of Segmented Rollers for Automated Fiber Placement

Theories and Control Technologies for Web Handling in the Roll-to-Roll Manufacturing Process

Influences of Wrinkles Induced by Tows’ Offset in Automated Fiber Placement on the Bending Properties of Composites

Effect of Environment Temperature on Web Tension in Shaft-Less Drive Gravure Printing System

Modeling and Analysis of Web Tension Between Two Adjacent Printing Rollers in Shaft-Less Drive Gravure Printing Systems

Heterogeneity characterization of commercial structural papers

Optimization of taper winding tension in roll-to-roll web systems

Initial wet web strength of paper

Thermal Characteristics of Plastic Film Tension in Roll-to-Roll Gravure Printed Electronics

Evaluation of Frictional Influence and Thermal Analysis of Flexible Paper‐Based Materials Used in the Vertical Form–Fill–Seal Process: An Experimental Study

A Finite-Deformation Mechanics Theory for Kinetically Controlled Transfer Printing

Effects of loom characteristics on the physical properties of PET fabrics for emotional clothing

An Analytical Study of Arabic Sentiments: Maktoob Case Study

New shapemeter roll technology based on Fiber Bragg Grating technology for on-line flatness monitoring of thin cold rolled metal sheets

Stress distribution of the nonwoven fabric package during winding

Research on Misalignment Detection of Paper Machine Clothing Based on Computer Vision

Reduction of Paper Pulp Fluctuations in Tissue Paper Making Machine

An analytical model for designing defect-free sheet metal profiles with height-variable cross sections manufactured by Flexible Roller Beading