Abstract:Abstract Surface modification of fabrics is an effective way to endow them with antifouling properties while still maintain their key advantages like comfort, softness, and stretchability. Herein, an atmospheric pressure dielectric barrier discharge (DBD) plasma method is demonstrated for the processing of silk fabrics using 1H,1H,2H,2H-perfluorodecyltriethoxysilane (PFDS) as the precursor. The results showed the successful grafting of PFDS groups on the surface of silk fabrics without causing damage. Meanwhile, the gas temperature is rather low during the whole processing procedure, suggesting the non-equilibrium characteristics of DBD plasma. The influence of processing parameters on fabrics was systematically investigated, like the PFDS concentration, plasma treatment time, and plasma discharge power. An optimum processing condition was determined to be PFDS concentration: 8 wt%, plasma processing time: 40 s, and plasma power: 11.87 W. However, with the prolonged plasma processing time or enhanced plasma power, the plasma-grafted PFDS films could be degraded. Further study revealed that plasma processing of silk fabrics with PFDS would lead to the change of their chemical composition and surface roughness. As a result, the surface energy of the fabrics was reduced, accompanied by the improved water and oil repellency properties as well as enhanced antifouling performance. Besides, the plasma-grafted PFDS films also had good durability and stability. By extending the fabrics to polyester and wool against different oil-/water-based stains, the DBD plasma surface modification technique demonstrated good versatility in improving the antifouling properties of fabrics. This work provides a guidance for the surface modification of fabrics using DBD plasma to confer them with desirable functionalities.

Surface properties of different natural precious decorative veneers by plasma modification

Role of surface treatment on water absorption of poly(vinyl chloride) composites reinforced by Phyllostachys pubescens particles

Surface Wettability and Coating Performance of Plasma-Treated Wood-Based Composite Panels

Bulk Polymerization of PEGDA in Spruce Wood Using a DBD Plasma-Initiated Process to Improve the Flexural Strength of the Wood–Polymer Composite

Effects of surface characteristics of wood on bonding performance of low-molar ratio urea–formaldehyde resin

Surface Modification and Mechanical Properties Improvement of Bamboo Fibers Using Dielectric Barrier Discharge Plasma Treatment

Surface modification of poplar veneer by means of radio frequency oxygen plasma (RF-OP) to improve interfacial adhesion with urea-formaldehyde resin

Research of polypropylene (PP) decorative board surface painting used for wood product decoration and the paint film adhesion improvement by plasma

Surface Modification Of Natural Fibers By Plasma For Improving Strength Properties Of Paper Sheets

Wood Surface Treatment Using Low-temperature Plasma

Surface Modification of PE Film by DBD Plasma in Air

Differential Etching of Rays at Wood Surfaces Exposed to an Oxygen Glow Discharge Plasma

Surface Modification of Fabrics Using Dielectric Barrier Discharge Plasma for Improved Antifouling Performance

Effect of Surface Coating and Plasma Treatment on Mechanical Properties of Wood Plastic Composites

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Improvement of PBO Fiber Surface and PBO/PPESK Composite Interface Properties with Air DBD Plasma Treatment

Effects of Air Dielectric Barrier Discharge Plasma Treatment Time on Surface Properties of Pbo Fiber

Polypropylene Surface Plasma Modification Using Middle Frequency Power Supply

Effects on Surface Properties of Natural Bamboo Fibers Treated with Atmospheric Pressure Argon Plasma

Surface wood modification by radio-frequency inductive plasma at atmospheric pressure

Surface Modification of Polyethylene (pe) Films Using Dielectric Barrier Discharge Plasma at Atmospheric Pressure