Abstract:The paper is aimed to introduce a non-contact measurement technology vit the Laser Doppler Anemometer(LDA) and Particle Image Velocimetry (PIV) instead of the traditionally used contact instantaneous velocity measurements in hoping to overcome the limitations of the airflow status in the straight roadway and the suddenly expanded cross-section.For the said purpose,we have managed to determine the measuring and testing areas of the pre-and-post sudden enlarged interface of the roadway.As the result of the measurement via LDA,we have found that the wind speed of the 10 cross-sectigns should be equal to 100 mm with the interval distance between the cross-sections being 100 mm.Since the moving step is 10 mm in the horizontal and vertical directions,each testing section should be divided into 289 measuring points before the enlargement but into 561 points after that.However,due to the limitation of the maximally observable range of the CCD camera,it wouldn't be possible for PIV to collect at once all the longitudinal data pre-and-post the sudden enlargement interface,which makes it necessary to divide the enlargement into two steps:in the first step,that is before the sudden enlargement,the test area can be made to reach 100 mm × 160 mm,while in the second step,that is,after the enlargement,the test area can be made to reach 220 mm× 320 mm.The experiment results have thus shown that all the information of the flow field in the sudden enlargement roadway has been obtained by PIV in a moment.Therefore,the velocity vector streamline in the straight roadway can be said smooth and straight in general,though large eddies may appear in the comer of such sudden enlarged areas with the velocity being unstable in the turning areas and small in magnitude (the mean velocity fluctuating between 0.1 m/s and 0.2 m/s,which indicates that the eddy zone can be conditionally neglected when the wind speed in the coal mine is measured to meet the needs of the projects.The statistical mean velocities of each point in the roadway cross-section measured by LDA tend to show that the velocity can directly increase to the mean value of the main stream when the points are just out of the wall,and the distribution of the wind speed in the cross-section has been shown as equal dynamic wavy lines rather than the quasi parabolic distribution,which is likely to be affected by the vortex in the sudden enlargement and the secondary flow.Furthermore,our study also proves that the LDA measurement technology in combination with PIV can be said qualified enough for testing the airflow change of the flow field characterized by the turbulence in the roadway.

Line average wind speed measurement system of roadway cross-section based on ultrasonic transit time Difference

An accurate ultrasonic wind speed and direction measuring method by combining time-difference and phase-difference measurement using coded pulses combination

A Model-Based Transit-Time Ultrasonic Gas Flowrate Measurement Method

Method for air velocity measurement with single-point under the influence of turbulent fluctuation

Speed estimation with single loop detector using typical effective vehicle length

Video-based efficient measurement of average control delay at signalized intersections

Flow Velocity Measurement Using a Spatial Averaging Method with Two-Dimensional Flexural Ultrasonic Array Technology

Experimental study on distribution laws of wind velocity in straight roadway section based on LDA

The Maximum Wind Speed Method to Improve Determination Accuracy of Roadway Air Volume

Estimation on Freeway Segment Average Speed Based on Probe Vehicle Data

1 Site-specific Wind Data Acquisition and Analysis with Geospatial Mobile Testing Technology

Research on rapid measurement of medium short wave longitudinal road profiles

A Novel Mathematical Model for Transit-time Ultrasonic Flow Measurement

[Measurement of Path Transverse Wind Velocity Profile Using Light Forward Scattering Scintillation Correlation Method].

Multipath Ultrasonic Gas Flow-Meter Based on Multiple Reference Waves

Realization of a Multipath Ultrasonic Gas Flowmeter Based on Transit-Time Technique.

Measuring Instrument of Atmospheric Environment Factors Based on Ultrasonic Velocimetry

Analysis of Speed Differences in Data from Remote Traffic Microwave Sensors and Floating Car Data Systems on Expressways

Investigation on Near-surface Wireless Wind Speed Profiler Based on Thermistors

Design of High Speed Cross Section Measurement System and Its Real-Time Performance Analysis

LDA/PIV joint experimental investigation for the airflow situation in-situ in the instantly extended roadway model