Abstract:This paper introduces a model to estimate average link travel time of signalized arterials using data obtained from stop-line detectors. The proposed model makes use of detectors at the upstream stop line of a link to capture the arrival of vehicles into the link at short intervals of 2 seconds, and a platoon dispersion sub-model to project the vehicle arrival times at the downstream stop line. Using the vehicle departure patterns obtained at detectors at the downstream stop line, the average link travel time is then calculated. The sensitivity of the estimated link travel time with Tracz, Pacey and Robertson platoon dispersion sub-models have been tested by means of microscopic traffic simulations. The results show that the accuracy of the link travel time is not sensitive to the different platoon dispersion sub-models. However, the Tracz sub-model was recommended for its smallest errors. The accuracy of the proposed model, with the calibrated Tracz platoon dispersion sub-model, has also been tested for link lengths between 300 m to 800 in, under different urban street level of service defined in the U.S. Highway Capacity Manual. Results indicate that the proposed link travel time estimation model has an average absolute error of 2.26 seconds, which is lower than the estimation errors given by the existing British, Illinois and Iowa arterial link travel time estimation models. Tests on the sensitivity of the coefficient of the Tracz platoon dispersion sub-model had also been carried out. It was found that the value of the Tracz platoon dispersion coefficient has minimal effect on the accuracy of the estimated average link travel time. The results of this paper has indicated that, with some modifications in the intersection signal controller's card to capture the arrival time and departure times of vehicles at interval of 2 seconds, it is possible to make use of existing stop-line detectors to collect detailed vehicle actuation data for link travel time estimation with reasonably good accuracy.

Speed estimation with single loop detector using typical effective vehicle length

Maximum likelihood method of speed estimation from single loop outputs

Research on Method of Speed Estimation from Single Loop Detector

Bayesian Network Method of Speed Estimation from Single-Loop Outputs

Real-Time Estimation of Vehicle-Count Within Signalized Links

Some Practical Vehicle Speed Estimation Methods by a Single Traffic Magnetic Sensor

An Extended Generalized Filter Algorithm for Urban Expressway Traffic Time Estimation Based on Heterogeneous Data

A Hybrid Model for Speed Estimation Based on Single-Loop Data

Traffic Demand Estimation for Lane Groups at Signal-Controlled Intersections Using Travel Times from Video-Imaging Detectors

Traffic State and Emission Estimation for Urban Expressways Based on Heterogeneous Data

Estimating Maximum Queue Length for Traffic Lane Groups Using Travel Times from Video-Imaging Data

Evaluation of Speed-Based Travel Time Estimation Models

Travel Time Estimation for Urban Arterials Based on the Multi-Source Data

Multi-Vehicle Speed Estimation Algorithm Based on Real-Time Inter-Frame Tracking Technique

Lane-Based Saturation Degree Estimation for Signalized Intersections Using Travel Time Data

AN IMPROVED VELOCITY ESTIMATION METHOD USING KALMAN FILTER

Grouped Travel Time Estimation in Signalized Arterials Using Point-to-point Detectors

Real-time Estimation of Vehicle Counts on Signalized Intersection Approaches Using Probe Vehicle Data

A Cell Probe-Based Method for Vehicle Speed Estimation

Queue Length Estimation for Signalized Intersections Using License Plate Recognition Data

ESTIMATION OF ARTERIAL TRAVEL TIME USING STOP-LINE DETECTORS WITH PLATOON DISPERSION MODELS