Abstract:The use of industrial solid wastes (e.g., slag, fly ash) and recycled concrete aggregate (RA) to manufacture geopolymeric recycled aggregate concrete (GRAC) has been proved as a sustainable and environment-friendly approach for the concrete industry, and has received an extensive prospect. Understanding the specimen size effect of GRAC is fundamental and essential in the entire design and analysis of concrete components and structures. This paper presents an experimental study on the specimen size effect on compressive and splitting tensile strengths of GRAC, with the influence of RA replacement ratio and water-to-binder (w/b) ratio emphasized. A total of 168 GRAC cubes with four different specimen sizes (70.7, 100, 150 and 200 mm) are tested. The results show that the compressive and splitting tensile strengths of GRAC decrease with increasing RA contents due to the increased amount of defects, with the decreasing amplitudes of about 4%–30.4% for compressive strength and 2.96%–34.91% for splitting tensile strength, respectively, except that their size effect becomes more apparent. While the strengths and specimen size effect degrees of GRAC all decrease with the increase of w/b ratio. Based on Weibull's, Bazant's and Capinteri's size effect laws (SELs), analytical models for SELs of compressive and splitting tensile strengths of GRAC are respectively established. The comparison results indicate that the Bazant's SEL is more suitable for the cubic compressive strength of GRAC, while the splitting tensile strength using Weibull's statistical SEL achieves the most accurate prediction results. Moreover, conversion factors are suggested for the transformation of the compressive and splitting tensile strength measurements of GRAC. Finally, a life cycle assessment method is conducted to evaluate the carbon emission potential of GRAC, which is proven to be a green and low-carbon construction material with an over 60% carbon reduction compared to cement-based plain concrete.

Probabilistic Conversion of the Compressive Strength of Cubes to Cylinders of Natural and Recycled Aggregate Concrete Specimens

Probabilistic Models of Concrete Compressive Strength and Elastic Modulus with Rubber Aggregates

High-strain Rate Compressive Behavior of Concrete with Two Different Substituted Recycled Plastic Aggregates: Experimental Characterization and Probabilistic Modeling

A Bayesian Model Updating Approach Applied to Mechanical Properties of Recycled Aggregate Concrete under Uniaxial or Triaxial Compression

High-strain Rate Compressive Behavior of Concrete Made with Substituted Coarse Aggregates: Recycled Crushed Concrete and Clay Bricks

Fundamental behaviour of recycled aggregate concrete - Overview I: strength and deformation

A review of experimental results on structural performance of reinforced recycled aggregate concrete beams and columns

Experimental and Statistical Evaluation of the Interaction Effect of Recycled Aggregate and Water/Cement Ratio on Concrete Compressive Strength

Eurocode 2 design of recycled aggregate concrete elements under compression: Evaluation through model uncertainties from tests on columns

Mechanical performance of concrete made with aggregates from construction and demolition waste recycling plants

Prediction of the mechanical properties of concrete incorporating simultaneous utilization of fine and coarse recycled aggregate

Tests and Simulation of the Bond-Slip between Steel and Concrete with Recycled Aggregates from CDW

Durability and shrinkage performance of concrete made with coarse multi-recycled concrete aggregates

Prediction Model for Compressive Strength of Porous Concrete with Low-Grade Recycled Aggregate

Experimental and numerical investigation of the bending, shear, and punching shear behavior of recycled aggregate concrete precast/prestressed hollow core slabs

The effectiveness of surrogate models in predicting the long-term behavior of varying compressive strength ranges of recycled concrete aggregate for a variety of shapes and sizes of specimens

PRODUCTION OF RECYCLED AGGREGATE FOR STRUCTURAL CONCRETE

Influence of Recycled Concrete Aggregate Type on Rheological Behaviour of Mixtures Proportioned Using the Equivalent Volume Method

The effect of specimen size on the unconfined compressive strength of cement-stabilized granular mixtures made of natural and recycled aggregates

Effect of recycled course aggregate from concrete debris on the strength of concrete

Specimen size effect on compressive and splitting tensile strengths of sustainable geopolymeric recycled aggregate concrete: Experimental and theoretical analysis