Abstract:In this paper, a comprehensive hybrid K-edge/XRF densitometer (HKED) device model is constructed using MCNP simulation. After the modeling process, a systematic simulation study is conducted to analyze the physical parameters and material selection of KED and XRF. The simulation results reveal that the optimal parameters for the X-ray tube are an X-ray source voltage of 160 kV and a 1 mm Fe filter. The sample should be placed in a vial with an inner diameter of 1.4 cm and an outer diameter of 2 cm. For the KED technique, the determined main parameters are a 1.9cm Fe filter rod and an inner diameter of 0.08cm for the collimator. For the XRF technique, the determined main parameters are a 0.01cm Gd filter and an inner diameter of 0.3cm for the collimator, with a detector angle of 150°. After selecting appropriate parameters, the average calibration factor Δμ of the KED technique was found to be 3.301 cm 2 ·g -1 , with a relative standard deviation (RSD) of 3.36%. Additionally, the comparison between the simulated and calculated values of uranium concentration revealed a minimum measurement error of 0.4%. The minimum detection concentration of KED for uranium solutions is approximately 1 g/L. For plutonium solutions ranging from 0.5 to 20g/L, linear fitting of the K a1 net peak area and plutonium concentration showed a coefficient of determination (R 2 ) of 0.999. The detection limit of XRF for plutonium measurement was 2.33✕10 -4 g/L. The linear fitting coefficients ( R 2 ) of uranium concentration versus K-edge transmission rate and plutonium concentration versus K a1 net peak area for the hybrid technique in measuring uranium-plutonium mixed solutions are determined as 0.999 and 0.996, respectively, demonstrating the response relationship of the HKED device to uranium and plutonium under different concentrations.

Quantitative XPS of plutonium: Evaluation of the Pu4f peak shape, relative sensitivity factors and estimated detection limits

Initial Characterization and Optimization of the Liquid Sampling-Atmospheric Pressure Glow Discharge Ionization Source Coupled to an Orbitrap Mass Spectrometer for the Determination of Plutonium

Determination of Plutonium Isotopes (Pu-238, Pu-239, Pu-240, Pu-241) in Environmental Samples Using Radiochemical Separation Combined with Radiometric and Mass Spectrometric Measurements

Determination of Femtogram-Level Plutonium Isotopes in Environmental and Forensic Samples with High-Level Uranium Using Chemical Separation and ICP-MS/MS Measurement.

A Rapid Method for Quantification OF 242Pu in Urine Using Extraction Chromatography and ICP-MS

Determination of Plutonium Isotopes (238pu, 239pu, 240pu, 241pu) in Environmental Samples Using Radiochemical Separation Combined with Radiometric and Mass Spectrometric Measurements

Determination of Pu-240/Pu-239 in Plutonium-containing Particle by Laser Ablation Multiple Collector Inductively Coupled Plasma Mass Spectrometry

Conversion electron spectrometry of Pu isotopes with a silicon drift detector

Neutron spectroscopy of plutonium using a handheld detection system

Determination of Ultra-Low Level Plutonium Isotopes (239pu, 240pu) in Environmental Samples with High Uranium.

Gamma-Ray Spectrometric Determination of Isotopic Ratios of Plutonium

Rapid and Simultaneous Determination of 238Pu, 239Pu, 240Pu, and 241Pu in Samples with High-Level Uranium Using ICP-MS/MS and Extraction Chromatography

System Optimization Study of Hybrid K-edge/XRF Densitometer for Uranium-Plutonium Solution Measurement

Non-destructive assay of plutonium in absence of gamma-ray spectrometry

A Reassessment of 5f Occupation in Plutonium

Simultaneous determination of femtogram levels of 237Np, 239Pu, and 240Pu in environmental solid samples using extraction chromatography and ICP-MS/MS

Analysis of Sub-picogram Plutonium by Isotope Mass Spectrometry

Quantification of aluminium and silicon‐containing materials using Ag Lα X‐rays

Determination of Pu isotope concentrations and isotope ratio by inductively coupled plasma mass spectrometry: a review of analytical methodology

Determination of plutonium isotopic composition by gamma-ray spectroscopy

Determination of plutonium isotopes in waters and environmental solids: A review.