Simulation and On-Site Detection of the Failure Characteristics of Overlying Strata under the Mining Disturbance of Coal Seams with Thin Bedrock and Thick Alluvium
Qunlei Zhang,Jianping Guo,Xiaowei Lu,Kunpeng Ding,Ruifu Yuan,Decai Wang
DOI: https://doi.org/10.3390/s24061748
IF: 3.9
2024-03-09
Sensors
Abstract:When mining deep coal seams with thin bedrock and thick alluvium, the collapse and fracture of thin bedrock layers may cause geological disasters, such as water inrush and sand inrush of the mining face. Comprehensively obtaining the response data of coal mining and reasonably analyzing the failure characteristics of overlying strata are helpful in guiding safe production. In this study, the caving zone heights of overlying strata are obtained by field detection during layered mining. Then, the caving zone heights during the once-full-height mining are evaluated by theoretical analysis. Further, the force and failure characteristics of coal–rock structures under different mining conditions are compared by the simulation detection and analysis. Finally, the results of on-site observation, theoretical analysis, and simulation detection are compared and discussed, and an optimized mining technology is proposed to ensure safe mining. The research shows the caving zone heights of on-site and simulation detections are, respectively, 14.65 m and 13.5 m during bottom-layer mining, which is larger than the caving zone heights of the top-layer coal mining. During once-full-height mining, the maximum caving zone height of simulation detection is 21 m, which is in between two standard results. For the mechanical responses of an aquiclude clay layer under thick loose alluvium, the maximum disturbance displacement of clay aquiclude is 5.8 m during layered mining, which is slightly larger than the disturbance displacement of once full-height mining; however, the maximum stress of the clay layer is 25 MPa during once-full-height mining, which is larger than the maximum stress of clay layer during layered mining. For the clay aquiclude failure, the clay layer during layered mining is in the deflection deformation area, and there is no obvious fracture structure to inrush the water and sand of thick loose alluvium; however, the clay layer during once-full-height mining is prone to produce obvious fracture structure. Therefore, the layered mining technology can effectively reduce and prevent the water/sand inrush disaster of mining working face.
engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation