Hybrid Microwave/Solar Energy Harvesting System Using 3D-Printed Metasurfaces
Argyri Drymiskianaki,Zacharias Viskadourakis,George Kenanakis
DOI: https://doi.org/10.3390/ma17235969
IF: 3.4
2024-12-07
Materials
Abstract:In this study, a hybrid energy harvesting system based on a conventional solar cell combined with 3D-printed metasurface units is studied. Millimeter-scale metasurface units were fabricated via the stereolithography technique, and then they were covered with conductive silver paint, in order to achieve high electric conductivity. The performance of single, as well as two-unit metasurface harvesters, was thoroughly investigated. It was found that both of them produced voltage, which peaks at their resonance frequency, demonstrating efficient energy harvesting behavior in the microwave regime. Then, the metasurface units were connected with a commercially available photovoltaic panel and the performance of the hybrid system was examined under different environmental conditions, modifying the light intensity (i.e., light, dark and shadow). It was shown that the proposed hybrid harvesting system produces a sizable voltage output, which persists, even in the case when one of the components does not contribute. Furthermore, the performance of the hybrid harvester is found to be adequate enough, although optimization of the harvesting circuit is required in order to achieve high efficiency levels. All in all, the presented experimental evidence clearly indicates the realization of a rather promising hybrid energy harvesting system, exploiting two distinct ambient energy sources, namely light and microwaves.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering