Abstract:The formation mechanism of an EFP(explosively formed projectile) using a double curvature liner under the overpressure effect generated by a regular oblique reflection was investigated in this paper. Based on the detonation wave propagation theory, the change of the incident angle of the detonation wave collision at different positions and the distribution area of the overpressure on the surface of the liner were calculated. Three-dimensional numerical simulations of the formation process of the EFP with tail as well as the ability to penetrate 45# steel were performed using LS-DYNA software, and the EFP velocity, the penetration ability, and the forming were assessed via experiments and x-ray photographs. The experimental results coincides with those of the simulations. Results indicate that the collision of the detonation wave was controlled to be a regular oblique reflection acting on the liner by setting the dimensions of the unit charge and maintaining the pressure at the collision point region at more than 2.4 times the CJ detonation when the incident angle approached the critical angle. The distance from the liner midline to the boundary of the area within which the pressure ratio of the regular oblique reflection pressure to the CJ detonation pressure was greater than 2.5, 2, and 1.5was approximately 0.66 mm, 1.32 mm, and 3.3 mm, respectively. It is noted that pressure gradient caused the liner to turn inside out in the middle to form the head of the EFP and close the two tails of the EFP at approximately 120μs. The penetration depth of the EFP into a 45# steel target exceeded 30mm, and there was radial expansion between the head and tail of the EFP, increasing the penetration resistance of the EFP. Therefore, the structural size of the unit charge and the liner can be further optimized to reduce resistance to increase the penetration ability of the EFP.

Research on the computing method for the forming velocity of circumferential multiple explosive formed projectiles

Strain-rate-dependent Cohesive Zone Modelling of Charge Damage Behavior when a Projectile Penetrates Multilayered Targets

Numerical Simulation of Multiple Explosively Formed Projectile Warhead Forming Characteristics considering Various Materials

Numerical simulation and experimental study on forming of pentaprism directional MEFP

Numerical Simulation of Effects of Cone Angle and Thickness on the Formation of MEFP

Numerical Approach in Predicting the Formation Process of Tandem Explosively Formed Projectile

A Effective Method of Computing EFP Velocity

Experimental and numerical study on the flight and penetration properties of explosively-formed projectile

Numerical Simulation Research On The Formation Of Mefp

Numerical Simulation and Experimental Study of LEFP on Impact Initiation Process of Charge with Shell

Numerical Simulationand Analysis of a New Double Shaped Charge Liner Formed Penetrator

Formation of explosively-formed projectile with tail fins using polygonal charges

A study on the surface overpressure distribution and formation of a double curvature liner under a two-point initiation

Research on Numerical Simulation of Tantalum Explosively Formed Projectile Forming Driven by Detonation

Influence of Cutting Reseau Factor on Formation of Astroid-Shaped MEFP

3 Dimensional Finite Element Simulation on Perforating Casing of Peroration Bullet

Calculation Model of the Axial Dispersion Distribution of Cylindrical-Warhead Fragments

Simulation Study on Formation Mechanism of Tapered & Spherical Group Liner Warhead

Method of Determining the Critical Impact Velocity of Energetic Devices

Study On The Influences Of Ignition Position On The Formation Of Shaped Charge With Double-Layer Spherical Segment Liners

Numerical Simulation and Analysis of a Combined Shaped Charge