Abstract:The formation mechanism of an EFP(explosively formed projectile) using a double curvature liner under the overpressure effect generated by a regular oblique reflection was investigated in this paper. Based on the detonation wave propagation theory, the change of the incident angle of the detonation wave collision at different positions and the distribution area of the overpressure on the surface of the liner were calculated. Three-dimensional numerical simulations of the formation process of the EFP with tail as well as the ability to penetrate 45# steel were performed using LS-DYNA software, and the EFP velocity, the penetration ability, and the forming were assessed via experiments and x-ray photographs. The experimental results coincides with those of the simulations. Results indicate that the collision of the detonation wave was controlled to be a regular oblique reflection acting on the liner by setting the dimensions of the unit charge and maintaining the pressure at the collision point region at more than 2.4 times the CJ detonation when the incident angle approached the critical angle. The distance from the liner midline to the boundary of the area within which the pressure ratio of the regular oblique reflection pressure to the CJ detonation pressure was greater than 2.5, 2, and 1.5was approximately 0.66 mm, 1.32 mm, and 3.3 mm, respectively. It is noted that pressure gradient caused the liner to turn inside out in the middle to form the head of the EFP and close the two tails of the EFP at approximately 120μs. The penetration depth of the EFP into a 45# steel target exceeded 30mm, and there was radial expansion between the head and tail of the EFP, increasing the penetration resistance of the EFP. Therefore, the structural size of the unit charge and the liner can be further optimized to reduce resistance to increase the penetration ability of the EFP.

Numerical Simulation and Experimental Study of LEFP on Impact Initiation Process of Charge with Shell

Numerical Simulation of Effects of Cone Angle and Thickness on the Formation of MEFP

Numerical Simulation of Multiple Explosively Formed Projectile Warhead Forming Characteristics considering Various Materials

Numerical Simulation On The Interference With High Velocity And Flat Head Penetrator By Lefp

Numerical Simulation Research On The Formation Of Mefp

Experimental and numerical study on the flight and penetration properties of explosively-formed projectile

A study on the surface overpressure distribution and formation of a double curvature liner under a two-point initiation

Simulation Study on Formation Mechanism of Tapered & Spherical Group Liner Warhead

Study On The Influences Of Ignition Position On The Formation Of Shaped Charge With Double-Layer Spherical Segment Liners

Numerical Simulation and Analysis of a Combined Shaped Charge

Effect of material characteristics of explosive on formation of collinear explosively formed projectile from warhead with double layer liners

Numerical Approach in Predicting the Formation Process of Tandem Explosively Formed Projectile

Research on the computing method for the forming velocity of circumferential multiple explosive formed projectiles

Lateral enhancement effect of reactive PELE: Two-step segmented simulation and analytical modeling

Numerical Simulationand Analysis of a New Double Shaped Charge Liner Formed Penetrator

Numerical simulation and experimental study on forming of pentaprism directional MEFP

Investigation of Forming Mechanism of Explosively Formed Projectiles with Tails

Investigation of Three-point Detonation Mechanism and Formation of Tails of EFP

Initiation of Shielded High Explosive Impacted by Energetic Fragment

Numerical Simulation of Effect of Initiation Position on Directed Performance of Warhead Fragment

Numerical Simulation on Low Ratio Length to Diameter Shaped Charge Warhead