Abstract:A magnetorheological (MR) damper has been manufactured and tested and a non‐linear model is discussed. The parameters for the model are identified from an identification set of experimental data; these parameters are then used to reconstruct the force vs. displacement and the force vs. velocity hysteresis cycles of the MR damper for the hysteretic model. Then experiments are conducted on a three‐storey frame model using impact excitation, which identifies dynamic parameters of the model equipped with and without the MR damper. Natural frequencies, damping ratios and mode shapes, as well as structural properties, such as the mass, stiffness and damping matrices, are obtained. A semi‐active control method such as a variable structure controller is studied. Based on the ‘reaching law’ method, a feedback controller is presented. In order to evaluate the efficiency of the control system and the effect of earthquake ground motions, both numerical analysis and shaking table tests of the model, with and without the MR damper, have been carried out under three different ground motions: El Centro 1940, Taft 1952, and Ninghe 1976 (Tangshan Earthquake in Chinese). It is found from both the numerical analysis and the shaking table tests that the maximum accelerations and relative displacements for all floors are significantly reduced with the MR damper. A reasonable agreement between the results obtained from the numerical analysis and those from the shaking table tests is also observed. On the other hand, tests conducted at different earthquake excitations and various excitation levels demonstrate the ability of the MR damper to surpass the performance of a comparable passive system in a variety of situations. Copyright © 2003 John Wiley & Sons, Ltd.

Comprehensive nonlinear seismic performance assessment of MR damper controlled systems using virtual real‐time hybrid simulation

Experimental Investigations on the Nonlinear Dynamics of Magnetorheological Dampers

Large-Scale Real-Time Hybrid Simulation for Evaluation of Advanced Damping System Performance

Comparative Studies of Semiactive Control Strategies for MR Dampers: Pure Simulation and Real-Time Hybrid Tests

Mechanics performance test of MR damper and its application in structural seismic response control

Experimental Investigation of the Seismic Control of A Nonlinear Soil-Structure System Using Mr Dampers

Magnetorheological damper control and simulation analysis for vibration reduction of nonlinear structure based on AFSMC algorithm

New magnetorheological damper and its application in semi-active control of structural seismic response

New Type Magnetorheological Damper And Its Application On Semi-Active Control Of Structural Seismic Response

Semi-active seismic control of an 11-DOF building model with TMD+MR damper using type-1 and -2 fuzzy algorithms

Experimental evaluation of the seismic performance of steel MRFs with compressed elastomer dampers using large-scale real-time hybrid simulation

Dynamic modelling and control of shear-mode rotational MR damper for mitigating hazard vibration of building structures

Experimental Study of the Semi‐active Control of Building Structures Using the Shaking Table

Semi-Active Control of Structures Incorporated with Magnetorheological Dampers Using Neural Networks

Seismic control of multi-degrees-of-freedom structures by vertical mass isolation method using MR dampers

Comprehensive Assessment of the Seismic Performance of an Innovative Hybrid Semiactive and Passive State Control System for a Low-Degree-of-Freedom Structure Using Real-Time Hybrid Simulation

Vibration control of seismic response of adjacent buildings coupled with semi-active MR dampers

Multidimensional vibration reduction control of the frame structure with magnetorheological damper

Smart passive system based on magnetorheological damper

An innovative methodology for hybrid vibration control (MR+TMD) of buildings under seismic excitations

Modeling of a viscoelastic damper and its application in structural control