Abstract:This article presents a 17.720.2 GHz eight-element four-beam RF-beamforming transmitter in 65-nm CMOS for satellite communication (SATCOM). The transmitter utilizes an analog scheme in the variable-gain amplifier (VGA) to achieve dB-in-linear gain control with a high dynamic range (DR), together with a current combining crossbar for a compact footprint. The vector-modulation-based (VM-based) phase shifter (PS) adopts the cancellation-based $G_\mathrm{m}$ units for low switching variation. Furthermore, eight PSs of each beam are split into two groups, with each group sharing the same tunable I/Q generator for low power consumption. Considering the increased peak-to-average power ratio (PAPR) caused by high-order modulation schemes and multibeam operation, the transmitter incorporates compact transformer-based Doherty power amplifiers (DPAs) with adaptive bias control to improve the power efficiency at back-off. The chip achieves a 31-dB gain-tuning range with a 0.283-dB step and a 360 $^{\circ}$ phase-shifting range with a calibrated 7-bit resolution. The measured root-mean-square (RMS) phase/gain errors induced by the VGA/PS are below 2.05 $^{\circ}$ /0.147 dB, respectively, which decouples phase/gain control. The transmitter achieves a maximum output 1-dB gain compression point (OP $_{\mathrm{1 dB}}$ ) of 17.9 dBm and a maximum saturated power ( $P_{\mathrm{sat}}$ ) of 18.9 dBm. The output element exhibits 29.3% drain efficiency (DE) at 6-dB power back off (PBO) from $P_{\mathrm{sat}}$ , which is 1.56/3.12 times over the normalized class-B/class-A implementations, demonstrating Doherty PBO efficiency enhancement. The chip occupies an area of 8.59 $\times$ 4.17 mm $^2$ and consumes 398 mW per element at OP $_{\mathrm{1~dB}}$ . Additionally, a 16-element linear array has been developed to showcase the capabilities of the multibeam operation and gain tapering.

Rectangular Grating Waveguide Slot Array Antenna for SATCOM Applications

The Design of a K-Band 256-Element Reconfigurable Multi-Beam Phased-Array for SATCOM Application

Design of a 64-Element Dual-Polarized Planar Receive Phased Array with Four Concurrent Reconfigurable Beams for Ka-Band SATCOM

Dual-Band Aperture-Shared Circular Polarized Array Antenna for X-/Ku-Band Satellite Communications

A K-Band 4-Element 8-Beam Phased-Array Receiver with Hybrid Vector Interpolation and Impedance-Adapted Multibeam Combining Techniques for Satellite Communications

A $K$-Band Four-Beam Transmitter with Decoupled Phase/Gain Control and Enhanced Power Back off Efficiency for SATCOM

A Compact Ka-Band Eight-Element Four-Beam Receiver for Low-Earth-Orbit Satellite Communications in 65-Nm CMOS

Ku-band Waveguide Slot Filtering Antenna Based on Metallic-Nail Metamaterial

Design of a Ku/Ka Quad-Band Reflectarray Antenna for Satellite Communications

Flat-Panel Wideband Dual-Circularly Polarized 8×8 Phased Array Antenna for SATCOM Applications

A 94 GHz Slot Array Fed by a WR10 Interface

Development of a Wideband Slotted Antenna Array with Low Profile and Low Sidelobe (Invited Paper)

K-/Ka-Band Planar Shared-Aperture Beam-Scanning Array Antenna for Simultaneous Transmitting and Receiving Low Earth Orbit Satellite Communication Terminal

Design of Coaxial-Fed Slot-Loaded Dual-Band Microstrip Antenna

Development of an X-Band Reflectarray Antenna for Satellite Communications

Wideband and Wide-Scan-Angle Circularly-Polarized VICTS-like Antenna with Polarization Converting Radiator for Ka-band SatCom

A 2.77-dB NF K-Band Four-Element Dual-Beam Phased-Array Receiver With 39-dB Tx-Band Rejection for SATCOM Applications

Millimeter-Wave Filtering Circularly Polarized Antenna Using Hybrid Radiation Modes for Satellite Applications

Compact 2 × 2 Circularly Polarized Aperture-Coupled Antenna Array for Ka-Band Satcom-on-the-Move Applications

An FSS-Backed Ku/Ka Quad-Band Reflectarray Antenna for Satellite Communications

A K -Band Broadband Circularly Polarized Slot Antenna Based on L-Shaped Waveguide Cavity