Abstract:Phase change materials (PCMs) are commonly used in latent heat storage systems. Two novel diatomite-based, shape-stabilized composite phase change materials (PCMs) were compounded by incorporating organic alcohol PCMs into diatomite. The chemical, morphological, and thermal performances of the composite PCMs were evaluated using Fourier transform infrared spectroscopy, scanning electron microscopy, and differential scanning calorimeter analyses. As the organic alcohol PCMs were incorporated into the diatomite pore structure, the resulting composite PCMs presented good chemical stability. The phase-change temperatures of the two composite PCMs (designated TC35 and HC42) were in the ranges 33.1-35.1 degrees C and 41.7-42.7 degrees C, respectively. The latent heats were 90.5 +/- 1.5 J/g and 92.6 +/- 1.3 J/g, respectively. PCM-contained wallboards (PCMWs) were then fabricated and attached to the exterior surface of a test room wall to evaluate their thermal performance against that of polystyrene plastic insulation wallboards. The impacts of both the wallboard location and the phase transition temperature on the PCMWs were investigated. It was observed that the external surface temperature of the PCMW was lower than that of the traditional polystyrene plastic insulation wallboard owing to the former's more favorable thermal storage capacity. The thermal resistance of the PCMWs, however, was too small to reduce the indoor cooling loads in summer. Enhancing the thermal insulation performance of the wallboard is required in order to obstruct the outdoor-to-indoor heat transfer and thus save daytime energy; however, this is unfavorable for heat dissipation at night. The optimal phase transition temperature was found to depend on not only the outdoor meteorological conditions but also the location of the PCMW.

Regeneration of Waste Diatomite from Palm Oil Production Process as a Support Material for PCMs in Thermal Energy Storage in Buildings

Pore Structure Modified Diatomite-Supported Peg Composites for Thermal Energy Storage

Characterization of paraffin/ultrasonic-treated diatomite for use as phase change material in thermal energy storage of buildings

Preparation and Thermal Properties of Stearic Acid/diatomite Composites As Form-Stable Phase Change Materials for Thermal Energy Storage Via Direct Impregnation Method

Thermal Properties of Diatomite Loaded with Fatty Acid-based Phase Change Materials

Preparation and characterization of modified diatomite/fatty acid form-stable phase change material

Preparation and Thermophysical Performance of Diatomite-Based Composite PCM Wallboard for Thermal Energy Storage in Buildings

Diatomite: A Promising Natural Candidate As Carrier Material for Low, Middle and High Temperature Phase Change Material

Preparation and Thermal Properties of Fatty Acid/diatomite Form-Stable Composite Phase Change Material for Thermal Energy Storage

Effect of Modified Diatomite Based Shape-Stabilized Phase Change Materials on Multiphysics Characteristics of Thermal Storage Mortar

Study on preparation and thermal properties of binary fatty acid/diatomite shape-stabilized phase change materials

Biomass-based Shape-Stabilized Phase Change Materials from Artificially Cultured Ship-Shaped Diatom Frustules with High Enthalpy for Thermal Energy Storage

Preparation and performance study of modified diatomite based PCM for construction

Mixed Mill-Heating Fabrication and Thermal Energy Storage of Diatomite/paraffin Phase Change Composite Incorporated Gypsum-Based Materials

Use of sustainable Phase Change Material (PCM) in mortars for building energy efficiency

Paraffin/Palygorskite composite phase change materials for thermal energy storage

Assessment of low-cost organic phase change materials for improving infrastructure thermal performance

Development of diatomite-based shape-stabilized composite phase change material for use in floor radiant heating

Study on Shape-Stabilised Paraffin-Ceramsite Composites with Stable Strength As Phase Change Material (PCM) for Energy Storage

Adjustable thermal property of polyethylene glycol/diatomite shape‐stabilized composite phase change material

Improving the thermal energy storage capability of diatom-based biomass/polyethylene glycol composites phase change materials by artificial culture methods