Abstract:Every company desires a profit, and its production system must continually develop and become more productive. Companies can boost their production productivity in a variety of ways, including by enhancing their production process system and removing impediments. This research was conducted at a company in Tangerang that specialized in manufacturing brake linings. On the basis of the results of field research, manufacturing department defects and inventory have been detected. The research phases employ the DMAIC model. The define phase employs SIPOC and CTQ diagrams. Using WAM to identify waste that happens through the distribution of questionnaires during the measurement phase. According to the measure stage's calculation, the company's current efficiency level is 26.85 percent. The DPMO value is 6,222.71 and sigma number indicates a quality level of 4.91. After learning the company's status, the research continued with an FMEA examination of the root cause. On the basis of the results of the analysis, proposals for changes to the brake linings production steps were made. The research was continued in the third phase, known as control, which consisted of recalculating the company's status after the implementation of modifications. The calculation findings demonstrate an increase in process cycle efficiency to 35.33 percent. In addition, a reduction in the value of faults per million opportunities resulted in the production of 4,524.88 products and an increase in the sigma level to 5.12. This demonstrates a gain in efficiency of 8.48%, a drop-in DPMO of 1,697.83 products, and a 0.21 increase in sigma value.

Lean Approach for Waste Reduction in Production Line by Integrating DMAIC, VSM, and VALSAT Method (Study Case: Assembling Bracket Manufacturing Automotive Industry)

Optimization of Production Processes through Lean Manufacturing Techniques in the Automotive Industry

Assessment of Man and Method Toward the Assembly Line Improvement in Automotive Manufacturing

WASTE REDUCTION IN BRAKE LINING PRODUCTS TYPE 51 HS USING LEAN SIX SIGMA METHOD

Study of the Predictive Mechanism with Big Data-Driven Lean Manufacturing and Six Sigma Methodology

The implementation of Lean Six Sigma approach to minimize waste at a food manufacturing industry

LEAN MANUFACTURING IMPLEMENTATION FOR NEW PRODUCT DEVELOPMENT EFFECTIVENESS: CASE STUDY ON THE INDUSTRY OF WIRE STEEL AND DERIVATIVES

Optimization of Process Flow in an Assembly Line of Manufacturing Unit through Lean Tools Execution

Application of lean Six Sigma methodology using DMAIC approach for the improvement of bogie assembly process in the railcar industry

Enhancing Automotive Part Quality in SMEs through DMAIC Implementation: A Case Study in Indonesian Automotive Manufacturing

Penerapan Lean Manufacturing Dengan Metode VSM (Value Sream Mapping) untuk Mengurangi Waste Pada Proses Produksi Pt.XYZ

Standardization and optimization of an automotive components production line

Productivity Improvement and Reduction of Lead Time in Manufacturing Industry Using Lean Tools

Utilizing Lean Six Sigma and Waste Assessment Model to Reduce Waste in the Hot Rolled Coil Production

Application Of Value Stream Mapping (VSM) In Manufacturing Industry (Case Study : Jati Beringin Sdn. Bhd.)

Lean six sigma methodology for waste reduction in ship production

Lean Manufacturing in Production Process in the Automotive Industry

Increasing Productivity of Furniture Factory with Lean Manufacturing Techniques (Case Study)

Implementation of Lean Manufacturing to Improve Production Efficiency: A Case Study of Electrical and Electronic Company in Malaysia

Integration of value stream mapping with DMAIC for concurrent Lean-Kaizen: A case study on an air-conditioner assembly line

An Experimental Examination of ‘5S’ Technique for Continuous Improvement of the Manufacturing Process