Abstract:The design and usability of a fully autonomous robotic control system (SunbYte - Sheffield University Balloon "lYfted" TElescope) for solar tracking and observational applications onboard high-altitude balloons are addressed here. The design is based on a six-step development plan balancing scientific objectives and practical engineering requirements. The high-altitude solar observational system includes low-cost components such as a Cassegrain-type telescope, stepper motors, harmonic drives, USB cameras and microprocessors. OpenCV installed from ROS (Robotic Operating System), python and C facilitated the collection, compression, and processing of housekeeping and scientific data. This processed data was then transmitted to the ground station through the launch vehicle's telecommunication link. The SunbYte system allows the brightest spot in the sky, the sun, to be identified, and a telescope pointed towards it with high enough accuracy that a scientific camera can capture images. This paper gathers and presents the results from primarily two missions with the High-Altitude Student Platform (HASP, NASA Balloon Program office and LaSpace). Additionally, a discussion will be made comparing these with an earlier iteration flown with the German-Swedish "REXUS/BEXUS" programme coordinated by the European Space Agency. By capturing and analysing a series of tracking images with the location of the Sun at the calibrated centre, the system demonstrated the tracking capabilities on an unstable balloon during ascent. Housekeeping sensor data was collected to further analyse the thermal and mechanical performance. The low temperature increased friction in the drive train and reduced the responsiveness of the harmonic drive actuation system. This caused some issues which require further work in future missions, for example, with SunbYte 4 and its work when flying with the HEMERA ZPB (Zero Pressure Balloon) program.

Pointing, acquisition, and tracking for the TBIRD CubeSat mission: system design and pre-flight results

TBIRD 200-Gbps CubeSat Downlink: System Architecture and Mission Plan

Body pointing, acquisition and tracking for small satellite laser communication

TeraByte InfraRed Delivery (TBIRD): a demonstration of large-volume direct-to-Earth data transfer from low-Earth orbit

Precise Pointing and Stabilization Performance for the Balloon-borne Imaging Testbed (BIT): 2015 Test Flight

A Compressed and High-Accuracy Star Tracker with On-Orbit Deployable Baffle for Remote Sensing CubeSats

VERTECS: A COTS-based payload interface board to enable next generation astronomical imaging payloads

Design of a testbed for the study of system interference in space CMB polarimetry

The SQUID Controller Unit for the LiteBIRD Space Mission: Description, Functional Tests and Early Performance Assessment

Precise Pointing of Cubesat Telescopes: Comparison Between Heat and Light Induced Attitude Control Methods

CuRIOS-ED: The Technology Demonstrator for the CubeSats for Rapid Infrared and Optical Surveys Mission

MinXSS-1 CubeSat On-Orbit Pointing and Power Performance: The First Flight of the Blue Canyon Technologies XACT 3-axis Attitude Determination and Control System

Mechanical design and development of SPRITE: a 12U CubeSat with a far-ultraviolet imaging spectrograph

Attitude Guidance for Constraining Star Tracker Elevation Angle During CubeSat-to-Ground Laser Pointing

The FIREBIRD-II CubeSat mission: Focused investigations of relativistic electron burst intensity, range, and dynamics

Green Bank Telescope: Overview and analysis of metrology systems and pointing performance

SunbYte: an autonomous pointing framework for low-cost robotic solar telescopes on high altitude balloons

Development of TRL5 Space Qualified Hardware for Tuning, Biasing, and Readout of Kilopixel TES Bolometer Arrays

The design and performance of CUBES -- a CubeSat X-ray detector

Beam Tracking for UAV Mounted SatCom on-the-Move with Massive Antenna Array

Refined Astrometry on Board a CubeSat