Abstract:The Astrophysics 2020 Decadal Report recommended a line of Probe missions with far-infrared imaging or spectroscopy capabilities. The achievable sensitivity of these FIR missions will be enabled by cooled telescopes and advanced cryogenic detector technologies, potentially resulting in up to three orders of magnitude improvement in sensitivity and mapping speeds up to more than a million times of those achieved so far with past missions. We have obtained NASA funding to build and demonstrate transition edge sensor (TES)-based kilopixel arrays with the properties that match the requirements for cryogenic far-infrared space missions: The arrays are very closely tileable in one direction and with a moderate gap in the other direction. This array architecture can meet the sampling and pixel number requirement of a few 10 4 pixels. Many details of the architecture have already been demonstrated individually, and the detector board will be optimized for the use of the latest cryogenic NIST 2D time-domain SQUID readout multiplexers with a high-density fanout scheme. Additionally, we will use flex lines that are very similar to those developed at Princeton University for the ACT project. This method allows virtually unlimited tileability of the detector arrays and thus a compact detector/readout design for future FIR instrumentation requiring large pixel counts. We already have a pixel design which, if implemented with TES operating at less than 100 mK, will meet the continuum sensitivity requirements for background-limited cryogenic space missions of NEP < 10 –18 W/√Hz). Furthermore, our array design will be compatible with lower noise TES designs for spectroscopy that we are currently demonstrating in our laboratory.

Development of TRL5 Space Qualified Hardware for Tuning, Biasing, and Readout of Kilopixel TES Bolometer Arrays

Development of the Low Frequency Telescope focal plane detector arrays for LiteBIRD

Detector fabrication development for the LiteBIRD satellite mission

Fabrication Process Control to Realize High Yield, Uniform, Repeatable Low-Frequency Detector Arrays for the LiteBIRD CMB Experiment

Digital Frequency Domain Multiplexer for mm-Wavelength Telescopes

Design of a testbed for the study of system interference in space CMB polarimetry

MNTES: Modeling Nonlinearity of TES detectors for Enhanced Cosmic Microwave Background measurements with LiteBIRD

Optimization of Time- and Code-Division-Multiplexed Readout for Athena X-IFU

Optimising the multiplex factor of the frequency domain multiplexed readout of the TES-based microcalorimeter imaging array for the X-IFU instrument on the Athena Xray observatory

Design of Large Low Noise Transition Edge Sensor Arrays for Future FIR Space Missions

Frequency Multiplexed SQUID Readout of Large Bolometer Arrays for Cosmic Microwave Background Measurements

The optical design of the LiteBIRD Middle and High Frequency Telescope

Multiplexed readout demonstration of a TES-based detector array in a resistance locked loop

Frequency domain multiplexing readout for large arrays of transition-edge sensors

Calibration of Transition-edge Sensor (TES) Bolometer Arrays with Application to CLASS

Simulation and Measurement of Out-of-Band Resonances for the FDM Readout of a TES Bolometer

System performance of a cryogenic test-bed for the time-division multiplexing readout for NewAthena X-IFU

Development of frequency domain multiplexing for the X-ray Integral Field Unit (X-IFU) on the Athena

Testbed preparation of a small prototype polarization modulator for LiteBIRD low-frequency telescope

CCAT: Detector Noise Limited Performance of the RFSoC-based Readout Electronics for mm/sub-mm/far-IR KIDs

The SQUID Controller Unit for the LiteBIRD Space Mission: Description, Functional Tests and Early Performance Assessment