Abstract:Limited biomass resources for ethanol production challenge its adoption as a fossil fuel substitute. To alleviate this constraint, methanol, with abundant production resources, is frequently proposed as a solution. Ternary blends of gasoline, ethanol, and methanol (GEM) are proposed as an alternative to binary gasoline and ethanol blends to ease the lack of feedstock for ethanol production. Furthermore, by incorporating a higher proportion of ethanol and methanol as low carbon fuels in ternary blends, the transport sector can effectively reduce its carbon footprint and contribute to mitigating the climate change issue. As a consequence, the impacts of these ternary blends, as well as Euro-6 gasoline, ethanol, methanol, E85, and M54 (the binary methanol-gasoline equivalent of E85), on the performance and emissions of a four-cylinder four-stroke 2.5-liter gasoline direct injection engine under ultra-lean conditions were evaluated. According to the study, Euro-6 gasoline fuel exhibited knocking and was unable to reach the minimum spark advance for best torque (MBT) operating point within the lambda range of 1–1.4 due to its lower RON and knock resistance. Conversely, methanol and the blends containing methanol demonstrated effectiveness in approaching the MBT point throughout the entire lambda sweep with less spark advance compared to ethanol, E85, and Euro-6 gasoline. Methanol and M54 maintained combustion stability up to lambda 1.9, while the GEM ternary blends and Euro-6 gasoline achieved stability up to lambda 1.85. Ethanol and E85, however, suffered degraded stability at lambda 1.8. Methanol had the lowest NOx and HC emissions during the lambda sweep, with ethanol second. At lambda 1.8, all tested fuels showed a substantial reduction in NOx emissions of 95 %–97 % compared to stoichiometric conditions. Under ultra-lean conditions, Methanol reduced HC emissions the most (51 %), while ethanol and E85 increased HC emissions at lambda 1.8 in comparison to Euro-6 gasoline. Methanol had the highest overall thermal efficiency because of its higher oxygen content and faster flame speed. E85 occupies the second position in the hierarchy of higher thermal efficiency, followed by the ternary blend G34E33M33 (containing equal volume percentages of gasoline, ethanol, and methanol at 33.3 % v/v each), which exhibits a similar trend to that of ethanol. Until lambda 1.7, all tested fuels were more efficient than Euro-6 gasoline; however, as lambda increased to 1.8, E85, ethanol, and G34E33M33 displayed lower efficiency levels.

Effects of ethanol, methyl tert-butyl ether and gasoline-hydrogen blend on performance parameters and HC emission at Wankel engine

Impact of ethanol, methyl tert-butyl ether and a gasoline–ethanol blend on the performance characteristics and hydrocarbon emissions of an opposed-piston engine

Engine Performance and Emissions of A Compression Ignition Engine Operating on the Diesel-Methanol Blends

Effect of using gasoline and gasoline-ethanol fuel mixture on performance and emissions in a hydrogen generator supported SI engine

Performance and emissions evaluation of a multi-cylinder research engine fueled with ethanol, methanol, gasoline Euro-6, E85, and iso-stoichiometric ternary GEM mixtures operated at lean conditions

The effects of hydrogen peroxide-ethanol blend/gasoline on the combustion and emission performance of a combined injection spark ignition engine

Numerical comparative analysis on performance and emission characteristics of methanol/hydrogen, ethanol/hydrogen and butanol/hydrogen blends fuels under lean burn conditions in SI engine

Impact of various lambda values on engine performance, combustion and emissions of a SI engine fueled with methanol-gasoline blends at full engine load

Effects of Water Ratio in Hydrous Ethanol on the Combustion and Emissions of a Hydrous Ethanol/Gasoline Combined Injection Engine under Different Excess Air Ratios

Effect of ethanol content, water injection, and compression ratio on combustion and detailed emissions in an SI-GDI engine

Influence of Ethanol Blended Diesel Enriched with Hydroxy Gas in Dual-Fuel Mode on Common Rail Direct Injection Engine

Investigation on Blending Effects of Gasoline Fuel with N-Butanol, DMF, and Ethanol on the Fuel Consumption and Harmful Emissions in a GDI Vehicle

Effect of gasoline additive on combustion and emission characteristics of an n-butanol Partially Premixed Compression Ignition engine under different parameters

The Effects of Ethylhexyl Nitrate on the Performance of Diesel Engine Fueled with Diesel and Gasoline Blends: from Engine Bench Test to Vehicle Driving Cycle Test

Combustion Conduct Of A Single-Cylinder Spark-Ignition Affected By Ethanol Fuel Mixtures of Supplement Hydroxy Gas (HHO)

Comparative study on combustion and emission characteristics of methanol/hydrogen, ethanol/hydrogen and methane/hydrogen blends in high compression ratio SI engine

Experiment of a gasoline engine fueled with gasoline-DMF blends and gasoline-alcohol blends

Influence of fuel system variations on performance and emission characteristics of combined air-wall-guided mode modified GDI engine with alcoholic fuels and exhaust gas recirculation

Environmental and performance impacts of 2-ethylhexyl nitrate and ethanol in diesel blends: A comprehensive study

Influence of methanol gasoline blend fuel on engine and catalyst performance

Unregulated Emissions from Gasoline Engine Using Ethanol-Blended Gasoline As Fuels