Interactions between anaerobic ammonium- and methane-oxidizing microorganisms in a laboratory-scale sequencing batch reactor

Karin Stultiens,Simon Guerrero Cruz,Maartje A. H. J. van Kessel,Mike S. M. Jetten,Boran Kartal,Huub J. M. Op den Camp
DOI: https://doi.org/10.1007/s00253-019-09976-9
IF: 5
2019-06-21
Applied Microbiology and Biotechnology
Abstract:The reject water of anaerobic digestors still contains high levels of methane and ammonium that need to be treated before these effluents can be discharged to surface waters. Simultaneous anaerobic methane and ammonium oxidation performed by nitrate/nitrite-dependent anaerobic methane-oxidizing(N-damo) microorganisms and anaerobic ammonium-oxidizing(anammox) bacteria is considered a potential solution to this challenge. Here, a stable coculture of N-damo archaea, N-damo bacteria, and anammox bacteria was obtained in a sequencing batch reactor fed with methane, ammonium, and nitrite. Nitrite and ammonium removal rates of up to 455 mg N-NO2− L−1 day−1 and 228 mg N-NH4+ L−1 were reached. All nitrate produced by anammox bacteria (57 mg N-NO3− L−1 day−1) was consumed, leading to a nitrogen removal efficiency of 97.5%. In the nitrite and ammonium limited state, N-damo and anammox bacteria each constituted about 30–40% of the culture and were separated as granules and flocs in later stages of the reactor operation. The N-damo archaea increased up to 20% and mainly resided in the granular biomass with their N-damo bacterial counterparts. About 70% of the nitrite in the reactor was removed via the anammox process, and batch assays confirmed that anammox activity in the reactor was close to its maximal potential activity. In contrast, activity of N-damo bacteria was much higher in batch, indicating that these bacteria were performing suboptimally in the sequencing batch reactor, and would probably be outcompeted by anammox bacteria if ammonium was supplied in excess. Together these results indicate that the combination of N-damo and anammox can be implemented for the removal of methane at the expense of nitrite and nitrate in future wastewater treatment systems.
biotechnology & applied microbiology
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: how to effectively deal with the still - existing high - concentration methane and ammonium in the effluent from anaerobic digesters, so as to prevent environmental pollution before these wastewaters are discharged into surface water. Specifically, the article explores the realization of effective removal of methane, ammonium, nitrite and nitrate through the interaction of simultaneous anaerobic methane oxidation (N - damo) and anaerobic ammonia oxidation (anammox) microorganisms in a sequencing batch reactor (SBR). ### Problem Background 1. **Problems with the Effluent from Anaerobic Digesters** - The effluent from anaerobic digesters contains high - concentration methane and ammonium. - These substances need to be treated before wastewater discharge, otherwise they will cause environmental pollution. 2. **Limitations of Existing Treatment Methods** - Traditional aerobic wastewater treatment systems are energy - intensive and costly. - For complete nitrogen removal, external electron donors usually need to be added. - At present, there are no known biological methods that can effectively remove dissolved methane. ### Solutions 1. **Advantages of Anaerobic Treatment Systems** - They can produce biogas (such as methane) for power generation. - The sludge production is low because anaerobic microorganisms grow slowly. 2. **Introduction of New Microbial Processes** - **Anaerobic Ammonia Oxidation (anammox)**: Using nitrite as the final electron acceptor, ammonium is oxidized to nitrogen and nitrate. - **Nitrite/Nitrate - Dependent Anaerobic Methane Oxidation (N - damo)**: Composed of NC10 phylum bacteria and methane - oxidizing archaea related to the ANME - 2d lineage, it uses nitrite or nitrate to oxidize methane. 3. **Research Objectives** - To establish a stable N - damo and anammox co - culture system in a laboratory - scale sequencing batch reactor. - To study the interactions between these microorganisms and their removal efficiencies for methane, ammonium, nitrite and nitrate. ### Main Results 1. **Efficient Pollutant Removal** - A nitrite removal rate of up to 455 mg N - NO₂⁻ L⁻¹ day⁻¹ and an ammonium removal rate of 228 mg N - NH₄⁺ L⁻¹ day⁻¹ have been achieved. - All the nitrate (57 mg N - NO₃⁻ L⁻¹ day⁻¹) produced by anammox bacteria was consumed, and the nitrogen removal efficiency reached 97.5%. 2. **Microbial Community Structure** - Under the conditions of nitrite and ammonium limitation, N - damo and anammox bacteria each account for about 30 - 40% of the community. - N - damo archaea increased to 20% and were mainly present in granular biomass. 3. **Functional Analysis** - About 70% of nitrite was removed through the anammox process. - Batch experiments showed that the anammox activity was close to the maximum potential, while N - damo bacteria performed poorly in the SBR and might be competitively eliminated by anammox bacteria when ammonium was oversupplied. In conclusion, this paper aims to explore and verify the feasibility of N - damo and anammox microorganisms in jointly treating methane and ammonium wastewater in a sequencing batch reactor, providing a new solution for future wastewater treatment systems.