Abstract:Background: The ability to measure joint kinematics in natural environments over long durations using inertial measurement units (IMUs) could enable at-home monitoring and personalized treatment of neurological and musculoskeletal disorders. However, drift, or the accumulation of error over time, inhibits the accurate measurement of movement over long durations. We sought to develop an open-source workflow to estimate lower extremity joint kinematics from IMU data that was accurate and capable of assessing and mitigating drift. Methods: We computed IMU-based estimates of kinematics using sensor fusion and an inverse kinematics approach with a constrained biomechanical model. We measured kinematics for 11 subjects as they performed two 10-min trials: walking and a repeated sequence of varied lower-extremity movements. To validate the approach, we compared the joint angles computed with IMU orientations to the joint angles computed from optical motion capture using root mean square (RMS) difference and Pearson correlations, and estimated drift using a linear regression on each subject's RMS differences over time. Results: IMU-based kinematic estimates agreed with optical motion capture; median RMS differences over all subjects and all minutes were between 3 and 6 degrees for all joint angles except hip rotation and correlation coefficients were moderate to strong (r = 0.60-0.87). We observed minimal drift in the RMS differences over 10 min; the average slopes of the linear fits to these data were near zero (- 0.14-0.17 deg/min). Conclusions: Our workflow produced joint kinematics consistent with those estimated by optical motion capture, and could mitigate kinematic drift even in the trials of continuous walking without rest, which may obviate the need for explicit sensor recalibration (e.g. sitting or standing still for a few seconds or zero-velocity updates) used in current drift-mitigation approaches when studying similar activities. This could enable long-duration measurements, bringing the field one step closer to estimating kinematics in natural environments.

Simultaneous Floating-Base Estimation of Human Kinematics and Joint Torques

Whole-Body Human Kinematics Estimation using Dynamical Inverse Kinematics and Contact-Aided Lie Group Kalman Filter

Multi-IMU Proprioceptive State Estimator for Humanoid Robots

JointTracker: Real-time inertial kinematic chain tracking with joint position estimation

Walking Trajectory Estimation Using Multi-Sensor Fusion and a Probabilistic Step Model

Proprioceptive External Torque Learning for Floating Base Robot and its Applications to Humanoid Locomotion

Contact Force and Joint Torque Estimation Using Skin

Real-time Physics-based Motion Capture with Sparse Sensors

Accurate Real-Time Joint Torque Estimation for Dynamic Prediction of Human Locomotion

Inertial sensor-based humanoid joint state estimation

OpenSense: An open-source toolbox for inertial-measurement-unit-based measurement of lower extremity kinematics over long durations

Human Whole-Body Dynamics Estimation for Enhancing Physical Human-Robot Interaction

Real-Time Human Motion Capture Based on Wearable Inertial Sensor Networks

Predictive simulation of human movement in OpenSim using floating-base task space control

Human pose recovery using wireless inertial measurement units

Real-time inertial lower body kinematics and ground contact estimation at anatomical foot points for agile human locomotion

The Kinetics Observer: A Tightly Coupled Estimator for Legged Robots

Enhanced Euler–Lagrange Formulation for Analyzing Human Gait With Moving Base Reference

Ultra Inertial Poser: Scalable Motion Capture and Tracking from Sparse Inertial Sensors and Ultra-Wideband Ranging

Upper Body Pose Estimation Using Wearable Inertial Sensors and Multiplicative Kalman Filter

Multibody Model with Foot-Deformation Approach for Estimating Ground Reaction Forces and Moments and Joint Torques during Level Walking through Optical Motion Capture without Optimization Techniques