Abstract:Achieving a viable process for three-dimensional (3D) printing of ceramics is a sought-after goal in a wide range of fields including electronics and sensors for harsh environments, microelectromechanical devices, energy storage materials, and structural materials, among others. Low laser absorption of ceramic powders renders available additive manufacturing (AM) technologies for metals not suitable for ceramics. Polymer solutions that can be converted to ceramics (preceramic polymers) offer a unique opportunity to 3D-print ceramics; however, due to the low viscosity of these polymers, so far, their 3D printing has only been possible by combining them with specialized light-sensitive agents and subsequently cross-linking them layer by layer by rastering an optical beam. The slow rate, lack of scalability to large specimens, and specialized chemistry requirements of this optical process are fundamental limitations. Here, we demonstrate 3D printing of ceramics enabled by dispensing the preceramic polymer at the tip of a moving nozzle into a gel that can reversibly switch between fluid and solid states, and subsequently thermally cross-linking the entire printed part "at-once" while still inside the same gel. The solid gel, which is composed of mineral oil and silica nanoparticles, converts to fluid at the tip of the moving nozzle, allows the polymer solution to be dispensed, and quickly returns to a solid state to maintain the geometry of the printed polymer both during printing and the subsequent high-temperature (160 °C) cross-linking. We retrieve the cross-linked part from the gel and convert it to ceramic by high-temperature pyrolysis. This scalable process opens up new opportunities for low-cost and high-speed production of complex three-dimensional ceramic parts and will be widely used for high temperature and corrosive environment applications, including electronics and sensors, microelectromechanical systems, energy and structural applications.

Continuous DLP ceramic 3D printing

Continuous DLP-based ceramic 3D printing using a composite oxygen-rich film

Optimized Zirconia 3D Printing Using Digital Light Processing with Continuous Film Supply and a Recyclable Slurry System

Digital light processing 3D printing of ceramic materials: a review on basic concept, challenges, and applications

Optimized Zirconia 3D Printing Using Digital Light Processing with Continuous Film Supply and Recyclable Slurry System

POLYMER-DERIVED SIC CERAMIC WITH TRIPLY PERIOD MINIMAL SURFACE STRUCTURE FABRICATION THROUGH DIGITAL LIGHT PROCESSING

Developing the optimized control scheme for continuous and layer-wise DLP 3D printing by CFD simulation

Formation mechanism and controlling strategy of lamellar structure in 3D printed alumina ceramics by digital light processing

Fabrication and characterisation of ceramics via low-cost DLP 3D printing

Fabrication of fine and complex lattice structure Al2O3 ceramic by digital light processing 3D printing technology

Oxygen-controlled Bottom-Up Mask-Projection Stereolithography for Ceramic 3D Printing

High-resolution multiceramic additive manufacturing based on digital light processing

Three-Dimensional Printing of Ceramics through "Carving" a Gel and "Filling in" the Precursor Polymer

Digital light processing of ceramics: an overview on process, materials and challenges

Study on Debinding and Sintering Processes for Ceramics Fabricated Using Digital Light Processing (DLP) 3D Printing

Photopolymerization-Based Three-Dimensional Ceramic Printing Technology

Optimizing the properties of vat photopolymerization 3D-printed SiC ceramics by multi-infiltration

Recent Innovations in Interfacial Strategies for DLP 3D Printing Process Optimization

Ceramic 3D Printing via Dye-Sensitized Photopolymerization Under Green LED

The influences of light scattering on digital light processing high-resolution ceramic additive manufacturing

Digital Light Processing 3d Printing of Batio3 Piezoelectric Ceramics