Abstract:Background An organ‐specific Positron emission tomography (PET) scanner can achieve the same sensitivity with much fewer detectors as compared to a whole‐body PET scanner, thereby substantially reducing the system cost. It can also achieve much better spatial resolution as compared to a whole‐body PET scanner since the photon noncollinearity effect is reduced by using smaller detector ring diameter. Consequently, the development of organ‐specific PET scanners with high spatial resolution, high sensitivity, and low cost has been a major focus of international research in PET instrument development for many years. Purpose The focus of this work is to develop high‐resolution depth encoding PET detectors with high timing resolution and a reduced number of signal processing electronic channels. Consequently, PET scanners tailored for specific organs can be developed with high spatial and timing resolutions, enhanced sensitivity, and affordable cost. Methods An 8 × 8 silicon photomultiplier (SiPM) array with a pixel size of 3 × 3 mm2 and a multiplexed signal readout circuit is coupled to one end of the lutetium yttrium orthosilicate (LYSO) array with a glass light guide between them to achieve a good crystal identification of small crystals by using only four position‐encoding energy signals. A 4 × 4 SiPM array with a pixel size of 6 × 6 mm2 and an individual readout circuit is coupled to the other end of the crystal array without a light guide to achieve a good coincidence timing resolution (CTR). The depth of interaction (DOI) of the detector is measured by ratio of the energies measured by the two SiPM arrays and can be used to correct the depth dependency of the timing. The flood histograms, energy resolutions (ERs), DOI resolutions, and CTRs of two detectors utilizing LYSO arrays with different crystal sizes were measured with each of the two SiPM arrays alternately placed at the front of the detectors. Results A better flood histogram was obtained by placing the 8 × 8 SiPM array in front of the detector. The depth dependency of timing was larger when the 4 × 4 SiPM array was placed at the front of the detector. A better CTR was obtained by placing the 4 × 4 SiPM array at the back of the detector as compared to placing it at the front of the detector if the depth‐dependent timing correction was not performed. If the depth‐dependent timing correction was performed, a better CTR can be obtained by placing the 4 × 4 SiPM array at the front of the detector. The first detector using a 12 × 12 LYSO crystal array with a crystal size of 1.95 × 1.95 × 20 mm3 provided a flood histogram with all crystals clearly resolved, an ER of 11.7%, a DOI resolution of 2.9 mm, and a CTR of 275 ps with the depth‐dependent timing correction. The second detector using a 23 × 23 LYSO crystal array with a crystal size of 0.95 × 0.95 × 20 mm3 provided a flood histogram with all but the edge crystals clearly resolved, an ER of 17.6%, a DOI resolution of 2.3 mm, and a CTR of 293 ps with the depth‐dependent timing correction. Conclusions PET detectors with small crystal cross‐sectional sizes, good DOI and timing resolutions and a reduced number of electronics channels were developed. The detectors can be used to develop high performance organ‐specific PET scanners.

On light sharing TOF-PET modules with depth of interaction and 157 ps FWHM coincidence time resolution

Depth-of-interaction study of a dual-readout detector based on TOFPET2 application-specific integrated circuit

Evaluation of High-Resolution and Depth-Encoding PET Detector Modules Based on Single-Ended Readout with TOFPET2 ASIC

A layered single-side readout DOI TOF-PET detector

DOI- and TOF-capable PET Array Detector Using Double-Ended Light Readout and Stripline-Based Row and Column Electronic Readout

Development of a Depth of Interaction Detector for Γ-Rays

Simulation study of a brain PET scanner using TOF-DOI detectors equipped with first interaction position detection.

Development of a Compact DOI–TOF Detector Module for High-Performance PET Systems

Improving the timing resolution of a time-of-flight and depth-of-interaction PET array detector

Depth‐encoding using optical photon TOF in a prism‐PET detector with tapered crystals

A Depth-Encoding Pet Detector That Uses Light Sharing And Single-Ended Readout With Silicon Photomultipliers

A depth-encoding PET detector using light sharing and single-ended readout with SiPMs.

TOF and DOI Capable SiPM-PET Detector Using Striplines That Provide Row and Column Based Measurements

A multi-resolution TOF-DOI detector for human brain dedicated PET scanner

Performance of a depth encoding PET detector module using light sharing and single-ended readout with SiPMs.

Advances in heterostructured scintillators: toward a new generation of detectors for TOF-PET

16-channel SiPM high-frequency readout with time-over-threshold discrimination for ultrafast time-of-flight applications

Development of a Prototype PET Scanner with Depth-of-interaction Measurement Using Solid-State Photomultiplier Arrays and Parallel Readout Electronics.

Characterization of TOF-PET Detectors Based on Monolithic Blocks and ASIC-Readout

High‐resolution TOF‐DOI PET detectors through the implementation of dual‐ended readout with SiPM arrays of different pixel sizes on the two ends

Optimization Of Crystal Surface Treatment For A Double Layer Depth Of Interaction Detector