Abstract:The use of room-temperature ionic liquids (RTILs) as media for electrochemical application is very attractive. In this work, the electrochemical deposition of silver was investigated at a glassy carbon electrode in hydrophobic 1-n-butyl-3-methylimidazolium hexafluorophosphate (BMIMPF6) and hydrophilic 1-n-butyl-3-methylimidazolium tetrafluoroborate (BMIMBF4) RTILs and in KNO3 aqueous solution by cyclic voltammetric and potentiostatic transient techniques. The voltammograms showed the presence of reduction and oxidation peaks associated with the deposition and dissolution of silver from AgBF4 in both BMIMPF6 and BMIMBF(4), resembling the redox behavior of AgNO3 in KNO3 aqueous solution. A crossover loop was observed in all the cyclic voltammograms of these electrochemical systems, indicating a nucleation process. From the analysis of the experimental current transients, it was shown that the electrochemical deposition process of silver in these media was characteristic of 3D nucleation with diffusion-controlled hemispherical growth, and the silver nucleation closely followed the response predicted for progressive nucleation in BMIMPF6 and instantaneous nucleation in KNO3 aqueous solution, respectively. Compared with these two cases, the electrochemical deposition of silver in BMIMBF4 deviated from both the instantaneous and progressive nucleation models, which could be controlled by mixed kinetics and diffusion. On the basis of the experimental results, it was shown that parameters such as viscosity and water miscibility of RTILs would affect the electrodeposition behavior of silver. Atom force microscopy was employed to probe the surface morphology of the silver deposit, and it showed that the shining electrodeposit of silver was fairly dense and separate nanoclusters of <100 nm were in evidence, corresponding to an island growth model. The strongly enhanced Raman scattering from the monolayer film of 4-mercaptobenzoic acid demonstrated that as-prepared silver nanoparticular film was surface-enhanced Raman scattering (SERS) active. The enhancement factor was calculated to be up to 9.0 x 10(5) and 1.0 x 10(6) for the silver film obtained in BMIMPF6 and BMIMBF4 RTILs, respectively.

Preparation of copper–silver alloy with different morphologies by a electrodeposition method in 1-butyl-3-methylimidazolium chloride ionic liquid

Effects of Cuprous Ion on Electrodeposition of Aluminum from AlCl 3 -BMIC Ionic Liquid

Electrodeposition and Electrocatalytic Properties of Silver–Copper Bimetallic Nanoalloy

Electrochemical Deposition of Silver in Room-Temperature Ionic Liquids and Its Surface-Enhanced Raman Scattering Effect.

Effect of APMImBr ionic liquid on the migration of silver in copper electrorefining

Electrolytic Etching of AZ91D Mg Alloy in AlCl3–EMIC Ionic Liquid for the Electrodeposition of Adhesive Al Coating

Electrodeposition of bright Al and Al-Mn coatings from AlCl3-EMIC ionic liquid

Effects of Refinement by Al Wires on the Al-deposition from AlCl3-EMIC at Room Temperature

A promising method for electrodeposition of aluminium on stainless steel in ionic liquid

Electrochemical Behavior of Cobalt from 1-Butyl-3-methylimidazolium Tetrafluoroborate Ionic Liquid

Electrodeposition of Nanocrystalline Chromium Coatings from 1-Butyl-3-methylimidazolium-hydrogen Sulfate Ionic Liquid

Synthesis of Morphology-Controlled Silver Nanostructures by Electrodeposition

[Electrochemical deposition of copper by using ionic liquids as additive and its surface-enhanced Raman scatting effect]

Electrodeposition mechanism and characterization of Ni-Cu alloy coatings from a eutectic-based ionic liquid

Effect of deposition potential on electrodeposition of Sn-Ag-Cu ternary alloy solderable coating in deep eutectic solvent

A new method for electrodeposition of Al coatings from ionic liquids on AZ91D Mg alloy in air

The Synthesis of Cu-Ag Core-Shell Bimetallic Nanoparticles for IC Bonding

On the Electrodeposition of Nickel–zinc Alloys from a Eutectic-Based Ionic Liquid

Synthesis of Bismuth with Various Morphologies by Electrodeposition

Electrochemical solid-state amorphization in the immiscible Cu-Li system: Size matters

Copper Recovery from Industrial Bimetallic Composite Ionic Liquids by Direct Electrodeposition and the Effect of Temperature and Ultrasound