Abstract:A novel LPSO containing Mg-5Y-2n-2Li-0.5Al alloy with superior mechanical behaviors and damping capacities was first developed in this paper. The microstructure evolution, mechanical and damping properties of Mg-5Y-2n-2Li-0.5Al alloy were analyzed and compared with those of Mg-5Y-2Zn-2Li alloy. The results indicated the extruded Mg-5Y-2n-2Li-0.5Al alloy exhibited bimodal grain structure, including fine dynamically recrystallized grains (DRXed grains) and coarse un-dynamically recrystallized (unDRXed) grains, accompanied by the produce of the 14H LPSO phase, Al 3 (Y, Zn) particle and nano-precipitates AlLi phase. Due to the strengthening effects of grain boundary, residual dislocation and precipitation, the ultimate tensile strength (UTS), tension yield strength (TYS) and elongation (EL) of the extruded Mg-5Y-2Zn-2Li-0.5Al alloy were 312 MPa, 229 MPa and 10.9%, respectively, which were higher than that those of the extruded Mg-5Y-2Zn-2Li alloy. In addition, the extruded Mg-5Y-2Zn-2Li-0.5Al alloy displayed good damping capacities at both room and high temperature (RT and HT), and its RT damping value (Q −1 ) at 5 × 10 −4 strain amplitude exceeded 0.01, which associated with a high density of movable dislocation. With rising the temperature, the extruded Mg-5Y-2n-2Li-0.5Al alloy possessed superior damping properties than the Al-free alloy, which derived from the grain boundary slide (GBS) and the activation of the incoherent interface between the Al 3 (Y, Zn) and α-Mg phase after adding Al element.

Microstructures and properties of as-cast rare Earth magnesium alloy with LPSO phase

The Microstructure and Mechanical Properties of As-cast Mg-10Gd-3Y-xZn-0.6Zr (x=0, 0.5, 1 and 2 Wt%) Alloys

Microstructures and Properties of As-Cast Mg;Zn;Y; and Mg;Zn;Y;Gd; Alloys with LPSO Phase

Microstructures and Mechanical Properties of Mg-10Gd-3Y-2Zn-0.5Zr Alloy

A Study on the Damping Capacities of Mg–Zn–Y-Based Alloys with Lamellar Long Period Stacking Ordered Phases by Preparation Process

Effect on Zn on Microstructures and Mechanical Properties of Mg–Gd–Y–Zn LPSO Alloys

Microstructures and Mechanical Properties of Mg–10Gd–6Y–2Zn–0.6Zr(wt.%) Alloy

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Microstructures and Mechanical Properties of Mg-2Y-xZn (x=1, 2, 3 At%) Alloys

Microstructures and Mechanical Properties of the Mg–8Gd–4Y–Nd–Zn–3Si (wt%) Alloy

Structural Features and Mechanical Properties of Mg-Y-Zn-Sn Alloys with Varied LPSO Phases

Microstructure and Mechanical Properties of Mg97Zn1Y2 Alloy Reinforced with LPSO Structure Produced by Rheo-Squeeze Casting

Microstructure and Damping Properties of LPSO Phase Dominant Mg-Ni-Y and Mg-Zn-Ni-Y Alloys

Microstructure and Mechanical Properties of Extruded Mg-Gd-Y-Zn-Zr Alloys Filled with Intragranular LPSO Phases

Mechanical Properties of the Mg-Gd-Y-Zn-Zr Alloys with Different Morphologies of Long-Period Stacking Ordered Phases

Microstructure and Mechanical Properties of LPSO Phase Dominant Mg85.8Y7.1Zn7.1 and Mg85.8Y7.1Ni7.1 Alloys

Enhanced Mechanical Properties of Mg-Gd-Y-Zn-Mn Alloy by Tailoring the Morphology of Long Period Stacking Ordered Phase

Simultaneously Enhanced Mechanical and Damping Properties of Mg–Zn–Y Alloys Reinforced with LPSO Phase

Enhanced strength and corrosion resistant of Mg-Gd-Y-Al alloys by LPSO phases with different Al content

Effects of Bulk LPSO Phases on Mechanical Properties and Fracture Behavior of As-Extruded Mg-Gd-Y-Zn-Zr Alloys

Effect of Al element on microstructure, mechanical properties and damping capacity of LPSO-containing Mg-Y-Zn-Li alloy