Abstract:With the rapid development of the semiconductor industry, fault diagnosis is an important task in routine operations to determine the root cause for faults that occur. A tool in manufacturing processes is equipped with a wide variety of sensors that record different types of process data. Wafers being processed are accompanied by a considerable amount of process data as a multivariate time series. Identifying the key process parameters and the corresponding process operations where faults occur can be used to facilitate the tasks of monitoring the process, maintaining the stability of the process, and stabilizing wafer production yield. This article proposes a novel solution procedure for fault diagnosis of wafer acceptance test (WAT) and chip probing (CP) using machine learning (ML). Based on the process flow of wafers and the corresponding process data, a sampling method, called synthetic minority oversampling technique (SMOTE), is first used to augment classification models with an imbalanced process dataset, and the best-practice SMOTE ratio is sought by using four competitive classifiers. By means of principal component analysis (PCA), the original data are transformed into visualizations to explore the distributions of good and bad lots of wafers. Based on the comparison of the four classifiers used in the test, the proposed logistic regression with data augmentation (LR-SMOTE) performs best. The ten most important features identified by using the LR are collected to determine potential failure operations. The identified failures in operations returned by using the proposed solution procedure for fault diagnosis of WAT and CP were confirmed by the engineers who work in the domain. Note to Practitioners—In semiconductor manufacturing practice, during the WAT and CP, domain engineers need to trace upstream the key process parameters and the corresponding key operations in the front-end-of-line (FEOL) process if any faults are detected in the -ack-end-of-line (BEOL) process. In fact, the FEOL and the BEOL are located in completely separate plants with different clean room standards. Bridging the information gap between these two different processes merits thorough scrutiny. Another challenge posed by fault diagnosis of WAT and CP is that the total number of features (i.e., process parameters) involved in the FEOL can be tens of thousands, leading to an adverse effect of data sparsity on model building.

Key Parameter Identification and Defective Wafer Detection of Semiconductor Manufacturing Processes Using Image Processing Techniques

Wafer fault detection and key step identification for semiconductor manufacturing using principal component analysis, AdaBoost and decision tree

Fault Diagnosis of Wafer Acceptance Test and Chip Probing Between Front-End-of-Line and Back-End-of-Line Processes

A Data-Driven Approach for Identifying Possible Manufacturing Processes and Production Parameters That Cause Product Defects: A Thin-Film Filter Company Case Study

A Method for Wafer Defect Detection Using Spatial Feature Points Guided Affine Iterative Closest Point Algorithm.

IC Assembly Product Inspection Using Image Processing Techniques

Machine Learning-Based Detection Method for Wafer Test Induced Defects

Using intelligent technology and real-time feedback algorithm to improve manufacturing process in IoT semiconductor industry

Automatic Detection of Chip Pin Defect in Semiconductor Assembly Using Vision Measurement

Full-flow surface defect identification method based on spot scanning scattering for unpatterned wafer

AUTOMATED DEFECT INSPECTION ALGORITHM FOR SEMICONDUCTOR-PACKAGED CHIPS

A Novel Industrial Chip Parameters Identification Method Based on Cascaded Region Segmentation for Surface-Mount Equipment

Hybrid Semiconductor Wafer Inspection Framework via Autonomous Data Annotation

Semiconductor Manufacturing Process Monitoring Based on Adaptive Substatistical PCA

Defective wafer detection using a denoising autoencoder for semiconductor manufacturing processes

Investigating a Machine Learning Approach to Predicting White Pixel Defects in Wafers—A Case Study of Wafer Fabrication Plant F

Multi-Stage Process Diagnosis Networks in Semiconductor Manufacturing

Data Visualization of Anomaly Detection in Semiconductor Processing Tools

A machine learning-based solution for modulated image analysis in lithography process stability diagnosis

A Principal Component Analysis Based Fault Detection Method in Etch Process of Semiconductor Manufacturing

Wafer defect detection method based on machine vision