Abstract:Scaling the areal density, while maintaining a proper balance between media signal-to-noise, thermal stability and writability will soon require an alternative recording technology. Heat Assisted Magnetic Recording (HAMR) can achieve this balance by allowing high anisotropy media to be written by heating the media during the writing process (e.g. by laser light) to temporarily lower the anisotropy. Three major challenges of designing a HAMR head that tightly focuses light and collocates it with the magnetic field are discussed: 1) Magnetic Field Delivery, 2)Optical Delivery, and 3) Integration of Magnetic & Optical Field Delivery Components. Thousands of these HAMR heads were built into sliders and HGAs, and optical and scanning electron micrograph images are shown. Scanning near-field optical microscopy (SNOM) characterization of the HAMR head shows that the predicted ~λ/4 full-width half-maximum (FWHM) spot size can be achieved using 488 nm light (124 nm was achieved). SNOM images also show that wafer level fabricated apertures were able to effectively eliminate sidelobes from the focused spot intensity profile. An MFM image of HAMR media shows that Non-HAMR (laser power off) was not able to write transitions in the HAMR specific media even at very high write currents, but transitions could be written using HAMR (laser power on), even at lower write currents. A cross-track profile is shown for a fully integrated HAMR head where the magnetic pole physical width is ~350 nm, but the written track is ~200nm, which demonstrates HAMR. A HAMR optimization contour shows that there is an optimum write current and laser power and that simply going to the highest write current and laser power does not lead to the best recording. Lastly, some prospects for advancing HAMR are given and a few key problems to be solved are mentioned.

Simulation on near-field light generated by a semiconductor ring resonator with a metal nano-antenna for heat-assisted magnetic recording

Nanoscale Thermal Analysis for Heat-Assisted Magnetic Recording

Novel aluminum near field transducer and highly integrated micro-nano-optics design for heat-assisted ultra-high-density magnetic recording

Micromagnetic Modeling for Heat-Assisted Magnetic Recording

A Numerical Investigation Of The Nanoscale Heat Transfer In Heat Assisted Magnetic Recording

HAMR Thermal Reliability via Inverse Electromagnetic Design

Flat Super-Oscillatory Lens for Heat-Assisted Magnetic Recording with Sub-50 Nm Resolution.

Near-Field Optical Coupling and Enhancement in Surface Plasmon Assisted Media for Heat Assisted Magnetic Recording

Nanocavity Induced Light Concentration for Energy Efficient Heat Assisted Magnetic Recording Media

Heat Assisted Magnetic Recording with Matching Media and Recording Head Field

Heat-Assisted Magnetic Recording’s Extensibility to High Linear and Areal Density

Studies of HAMR Recording by Hybrid Monte Carlo Micromagnetics

Heat Assisted Magnetic Recording with A Fully Integrated Recording Head

A Study of Snr and Ber in Heat-Assisted Magnetic Recording

A model of heat transfer in STM-based magnetic recording on CoNi/Pt multilayers

Dynamic Simulation of High-Density Perpendicular Recording Head and Media Combination

Integrated Near Field Transducer Heat Assisted Magnetic Recording Head: Design And Recording Demonstration

Head Flying Characteristics in Heat Assisted Magnetic Recording Considering Various Nanoscale Heat Transfer Models

A Novel Design of Capacitive Plasmonic Near Field Transducer

Heat-assisted Magnetic Recording by a Near-Field Transducer with Efficient Optical Energy Transfer

Back Heating Effect of Media Hot Spot at Nanoscale Head–disk Interface