Abstract:The two-phase loop thermosyphon (TPLT) is a highly efficient passive heat transfer device that is widely applied in various fields. This paper experimentally and numerically investigates the thermal response performance of a large-scale TPLT under various convective boundary conditions. Experimental studies have been carried out to explore the effects of different working fluids, filling ratios, cold and heat source temperatures, and mass flow rates on the thermosyphon's performance. Meanwhile, a two-dimensional Computational Fluid Dynamics (CFD) simulation model of the TPLT is established and validated. The results indicate that the start-up procedure of the TPLT is highly dependent on the heat source temperature and the working fluid. Normally, the TPLT can start when the heat source reaches a certain temperature. In general, using methanol as the working fluid is more favorable to start-up compared to the water and ethanol TPLTs. The experimental results also show that the heat transfer capacity of the TPLT increases with increasing heat source temperature while increasing cooling temperature decreases heat transfer capacity. The best heat transfer performance of a TPLT charging methanol is observed at a filling ratio of 70 % with a heating mass flow rate of 1 L/min. At that point, the convective heat transfer coefficient of outside the evaporator is 1036.7 W/(m 2 ·K). Moreover, the simulation results reveal that the average wall heat flux of the TPLT's evaporator initially decreases and then gradually stabilizes with time. During stable operation, the wall heat flux density of the evaporator exhibits an initial increase in the pool section followed by a subsequent decrease with increasing wall height. This work provides insight into the heat and fluid flow characteristics of the TPLT under convective boundary conditions.

Experimental and Numerical Analysis of Start-Up of a Capillary Pumped Loop for Terrestrial Applications

Experimental Investigation of a Small Capillary Pumped Loop Subjected to Antigravity

Experimental and Numerical Investigation on the Dynamic Characteristics of a Lab-Scale Transcritical CO2 Loop

Startup Characteristics of Pump-Assisted Capillary Phase Change Loop

Analysis of Temperature and Pressure Stability in Capillary Pumped Loops

Numerical Study on Transient Performance of Mixed Flow Pump During Starting Period

Study on the Transient Characteristics of Pump During the Starting Process with Assisted Valve

An experimental investigation on capillary pumped loop with the meshes wick

The Start-Up Characteristics of a Novel Loop Heat Pipe with Stainless Steel Capillary Wick

Experimental investigation on startup of a novel two-phase cooling loop

Experimental Study on the Heat Transfer Performance of Pump-assisted Capillary Phase-change Loop

Investigation of the thermal response characteristics of the loop thermosyphon under convective boundary conditions

Experimental And Numerical Simulation On The Starting Period Of A Centrifugal Pump

Modeling and simulation of the cavitation phenomenon in turbopumps

Application of Cu-water and Cu-ethanol Nanofluids in a Small Flat Capillary Pumped Loop

Thermofluidic behavior of a 2-m nitrogen-charged cryogenic capillary pumped loop during its supercritical startup

Experimental study on the transient behaviors of mechanically pumped two-phase loop with a novel accumulator for thermal control of space camera payload

Experimental Investigation on Startup Performances of a Separator Assisted Two-Phase Loop Thermosyphon

Numerical Investigation of Flow and Structural Characteristics of a Large High-Head Prototype Pump–Turbine during Turbine Start-Up

Visual Investigation on Startup Characteristics of a Novel Loop Heat Pipe

Investigation on Heat and Mass Transfer in A Evaporator of A Capillary-Pumped Loop with the Lattice Boltzmann Method: Pore Scale Simulation