Abstract:Pipelines are widely used in energy power system including thermal power plants and nuclear power plants. In the power system, especially nuclear power plants, as thermal stratification characteristic of nonuniform temperature distribution in the pipe and thermal fatigue such as the low cycle thermal fatigue due to existence of the cycle thermal stress are inevitable, the pipe line system can be destroyed easily and thus affect the normal operation of the power plants. In order to study the pipeline thermal fatigue, the pipeline thermal stress needs to be calculated and therefore the temperature distributions especially the inner wall temperature was needed. The outer wall temperature and working fluid temperature can be obtained with installing measuring tools. The key and difficult point is the estimation of the inner temperature distribution of the pipe. At the same time, in the practical engineering, the pipeline structure with special safety requirements or higher requirements for structural completeness are not allowed to be destroyed by the measuring equipment. Based on the consideration above, this paper presents a method of solving the inverse heat conduction problem, which means the inner temperature distributions can be derived by the outer wall temperature distributions. For the pipe inverse heat conduction problem, this paper applies numerical analysis as the main way. Firstly, the method for transient inverse heat conduction problems applying separation of variables and Duhamel's theorem is established. As the effects of the random error on the measured outer wall temperature are inevitable, the measured data need to be smoothed before used as an input. The Gram orthogonal polynomial method based on the digital filtering theory is applied in this paper to accomplish the smoothing process. The inverse process is accomplished by using MATLAB programming. Then this method is verified in the experiment with high temperature and high pressure. In order to directly validate the accuracy of the inverse analysis, for the test section, not only the transient outer wall temperature and fluid temperature were measured, but also the time dependent middle layer temperature were measured. Then the middle layer temperature obtained from inverse calculation was compared with the measured data from the experiment. The calculated results show that the accuracy of this method is high. The temperature distributions along the radical direction can be obtained quickly and accurate instantaneous heat load for the structural stress analysis and thermal fatiglie analysis can be provided using this method. (CSPE)

Development of A Process for Predicting the Overall Heat Transfer Coefficient for Transient Heat Transfer in An Exhaust System using CFD

Analytical Solution of Heat Conduction for Hollow Cylinders with Time-Dependent Boundary Condition and Time-Dependent Heat Transfer Coefficient

Computational and statistical analysis on the U‐tube heat exchanger with different passes configuration: Taguchi method

Optimisation and comparison of performance parameters of a double pipe heat exchanger with dimpled twisted tapes using CFD and ANN

A Numerical Solution For The Transient Inverse Heat Conduction Problem

A comprehensive heat transfer prediction model for tubular moving bed heat exchangers using CFD-DEM: Validation and sensitivity analysis

Development and Analysis of Heat Exchanger for Efficient Heat Transfer for L-Shape Wind Tunnel

DESIGN AND SIMULATION OF SHELL-AND-TUBE HEAT EXCHANGER (STHE) WITH THE EFFECT OF BAFFLES USING CFD-TOOL

Design and Analysis of X Shaped Exhaust System Operation Using Different Types of Profiles on High Capacity Vehicle

Transient Analysis of A Cylindrical Heat Pipe Considering Different Wick Structures

Compact heat exchangers – Design and optimization with CFD

A Transient Heat Current Model for Dynamic Performance Analysis and Optimal Control of Heat Transfer System

Thermal and Conjugate Heat Transfer Analysis of Exhaust Manifold of Multi-cylinder IC Engine

Simulation Study on Cyclic Transient Heat Transfer of Piston-cylinder Liner

Heat Transfer and Thermal Load Analysis of Exhaust Manifold

A Numerical Approach to Study the Steady State Heat Transfer Characteristics of an Annular Porous Heat Exchanger

Natural convective heat transfer analysis of a vertical tapered inner annulus tube with dual inverted frusto-conical turbulator using CFD

Enhancing the Overall Heat Transfer Coefficient through Tube Rotation of a Heat Exchanger: An Analytical Approach

Numerical simulation of thermal loads for engine exhaust manifold

Multi-scale Thermal Analysis Approach for the Typical Heat Exchanger in Automotive Cooling Systems

Numerical Prediction and Analysis of the Dynamic Behavior of Heat Exchangers with Continuous Helical Shaped Baffles