Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. Strict environmental laws increase the importance of reducing emissions. While; improving three-way catalyst (TWC) technology can help reduce emission levels, attention should also be given to reducing exhaust gases before they enter the TWC. This can be achieved through the development of engine technology and calibration strategies. By doing so, low-cost TWC can be used, and emissions increase less after catalyst aging. In addition to reducing emissions at the engine-out stage before entering the TWC, it is important to reduce emissions after the TWC during the cold start and engine warm-up phase, known as the TWC light-off period. During this stage, the TWC does not reach optimal working efficiency, which can result in higher emissions. Therefore, to comply with environmental regulations, it is necessary to calculate the reduction of emissions while maintaining optimal engine and vehicle performance. Finding the optimal values of control parameters to reduce fuel consumption and emissions simultaneously makes engine calibration a complex multi-objective optimization problem. To meet calibration requirements, it is essential to accurately identify the nonlinear and multivariable behavior of engines. Thus, this study focuses on empirical engine modeling and developing an emissions model for internal combustion engines in both warm and cold engine conditions through an intelligent identification method. To enhance steady state engine modeling in warm conditions, this study proposes a hybrid MLP+CNN method based on the benefits of regression deep neural network. Additionally, the hybrid MLP+CNN+LSTM method adds a long short-term memory (LSTM) neural network, enabling the model to capture the dynamic behavior of emissions during cold start conditions and under the impact of oxygen storage and the temperature in TWC. The results demonstrate that these approaches significantly improve the accuracy of emission modeling when compared to conventional methods. The results demonstrate that using the deep learning approach and dividing the engine emission modeling into two parts, static in warm conditions and dynamic in cold conditions, significantly improve the accuracy of emission modeling compared to conventional methods. Developed models can be used in the model-based calibration due to their high accuracy in emission prediction as well as predicting Torque, BSFC, and other outputs. By coupling the developed model with optimization techniques, calibration of the engine map and cold start can be performed by considering the emissions, torque, etc., simultaneously.

High-pressure exhaust gas recirculation line condensation model of an internal combustion diesel engine operating at cold conditions

Multidimensional Computational Fluid Dynamics Combustion Process Modeling of a 6V150 Diesel Engine

Three-Dimensional Computational Fluid Dynamics Modeling of a 6V150 Diesel Engine

Study of In-Cylinder Heat Transfer Boundary Conditions for Diesel Engines under Variable Altitudes Based on the CHT Model

Development of a semi-empirical physical model for transient NOx emissions prediction from a high-speed diesel engine

Numerical simulation of the diesel engine starting considering air pre-heating in the intake system

Model development and experimental validation of an exhaust brake supported dual loop exhaust gas recirculation on a medium duty Diesel engine

Three-Dimensional Computational Fluid Dynamics Modeling of the Combustion Process of a MAN L21/31 Marine Diesel Engine

Numerical Modeling of Diesel Engine Combustion and Emissions Under HCCI-Like Conditions With High EGR Levels

Modeling Heavy-Duty Engine Thermal Management Technologies to Meet Future Cold Start Requirements

Thermal Regime of Automobile Exhaust System at Low Temperature

Reducing Cold Start Emissions from Automotive Diesel Engine at Cold Ambient Temperatures

Improving Cold Start and Transient Performance of Automotive Diesel Engine at Low Ambient Temperatures

Start of Low Temperature Reactions Detection Based on Motoring Pressure Prediction for Partially Premixed Combustion

Evaluation of thermal management technologies for fuel efficient cold-start emissions reduction in diesel engines

Prediction of emission and performance of internal combustion engine via regression deep learning approach

Modeling of a DOC SCR-F SCR Exhaust Line for Design Optimization Taking Into Account Performance Degradation Due to Hydrothermal Aging

Experimental study of SCR DeNO X efficiency at low exhaust gas temperatures

Diesel combustion modelling using LES turbulence model with detailed chemistry

Development of a cold-start emission model for diesel vehicles using an artificial neural network trained with real-world driving data

Computational Modeling and Analysis of Diesel-fuel Injection and Autoignition at Transcritical Conditions