Abstract:Over the last decades ink-jet-printing has developed in many applications. The di-rect writing of materials such as silver (for conductive circuits) or polymers (for insulation or second layer) is an attractive method to reduce costs and save raw materials. For conductor paths silver inks with nanoparticles are used. To ensure a good dispersion the nanoparticles are mostly covered with organic compounds. To guarantee electrical conductivity the organic compounds have to be removed and the particles have to be sintered to minimize resistivity. This is done by heating up the silver structures. In this article we compare different meth- ods of sintering conductive paths printed using a silver ink with a particle size of ≤ 50 nm. The methods of sintering are the established thermal sintering in an oven, and alternatively laser sintering as well as electrical resistive sintering. Laser sintering is carried out with a semiconductor laser with a wavelength of 408 nm and different feeding speeds so the energy input in the structures can be varied. For electrical resistive sintering a DC-current is injected to the structures whereby they are heated up by the current. During electrical sintering the actual value of the resistance of the hot structures can be observed. Thereby the sintering can be stopped, when a certain value (of the hot structure) is reached. The best parameters for both sintering alternatives are identified. The conductivity and the deviation of the conductivity of the sintered paths are determined and compared with the results achieved for thermal sintering. As a result, it can be stated, that both alternatives pro-vide specific advantages over thermal sintering such as lower deviations of the measured values or significantly lower process times. On the other hand, specific limitations might occur when using laser or electrical sintering. Additionally, the individual amount of energy input for the three respective sintering pro-cesses is calculated and compared with each other to determine the most energy efficient sintering method. Also the process of direct contacting electrical devices with ink-jet-printing is compared with the standard process wire bonding related to the consumption of material and energy.

Near-IR sintering of conductive silver nanoparticle ink with in situ resistance measurement

Water vapor-assisted sintering of silver nanoparticle inks for printed electronics

Investigation of Different Sintering Methods on Ink-Jet-Printed Conductive Structures

Comparing low-temperature thermal and plasma sintering processes of a tailored silver particle-free ink

Inkjet-printed silver tracks: low temperature curing and thermal stability investigation

Enhancing the electrical properties of inkjet-printed silver ink by electrolyte sintering, photonic sintering, and electroless plating

Preparation of Nano-Silver Conductive Ink and Electrode Properties

Green Approach to Prepare Silver Nanoink with Potentially High Conductivity for Printed Electronics

Silver content effect on rheological and electrical properties of silver pastes

Effectiveness of Oxygen during Sintering of Silver Thin Films Derived by Nanoparticle Ink

Direct visualization of nanoparticle morphology in thermally sintered nanoparticle ink traces and the relationship among nanoparticle morphology, incomplete polymer removal, and trace conductivity

An conductive ink based on silver oxide complex for low-temperature sintering with dense conductive paths

Mechanical and thermal reliability of conductive circuits inkjet printed on flexible substrates

Nano-Silver Ink of High Conductivity and Low Sintering Temperature for Paper Electronics

Low-temperature sintering of silver patterns on polyimide substrate printed with particle-free ink

Inkjet Printing of Polyacrylic Acid-Coated Silver Nanoparticle Ink onto Paper with Sub-100 Micron Pixel Size

Conductivity enhancement of Ag nanowire ink by decorating in situ formed Ag particles under low-temperature sintering

Fabrication of Polymer Silver Conductor Using Inkjet Printing and Low Temperature Sintering Process

Grain Structure Engineering in Screen-Printed Silver Flake-Based Inks for High-Temperature Printed Electronics Applications

Physical Characteristics of Sintered Silver Nanoparticle Inks with Different Sizes during Furnace Sintering

Preparation of low-temperature sintered high conductivity inks based on nanosilver self-assembled on surface of graphene